IP Telephony and Phones

IN Call Manager 6 you can associate a user to a line that has been applied to a device. Does anyone know if there is a way to BAT this process?

HiI have had now tried for some time to get some Cisco 7960 to work.So far i have managed to get them to find and load files from the Tftp, although it doesn't seem like they can find the SIP"MAC-adress".cnf and load this.Also the phones write up som...

Hi, we are using the CUCM 6.1 and just purchased additional 10*7945G and additonal licenses for CUCM and unity. For the CUCM license increasing, I uploaded two .lic files to pub but only 11 units increasd when I run the license report. This is my fir...

Hi,I have an employee in another state that I would like to be a part of our phone system.  Our phone system is UC520.  The employee has a Cisco IP Phone Model Number CP-7940G.  I would like to be able to dial an extension and reach that phone.  How ...

Has anyone experienced issues upgrading to CUCM 8.x? And where does Cisco publish bug, fixes or issues for 8.x? Is there a scheduled patch for 8.0 yet? Any recommendations or experiences upgrading from version 6.1 to 8.0? Thanks!

Hi,I'm resolving an issue for 1 specific phone, which is experiencing a audio silence for 30 secs. This phone that I been analyzing, once it recieve a call we hear nothing for about 30 secs, the caller then just hangup the phone, the caller probably ...

I hav 2 mgcp gateways with pri terminated on them. when publisher goes down i hear a fast busy tone on dialing the pri no. Attached is the capture of sh ccm-manager from both gateways when publisher and subscriber both r available. what is the reason...

I am preetty sure the answer is "No", but just checking to see if there is a way to have model specific ring lists or is it one listfor all phones regardless of any variables?  Thanks!

Dear Support,I just noticed one thing about CUCM that when I ping(extended) CUCM 6.x or 7.x form PC there is no packet loss but when I ping the same CUCM from cisco switch on which these servers are connected there is a specific packet drop pattern:C...

user wants to when click button "voice message" on IP phone can listening the voice message directly , not prompt modification greating .how do I operate in CUE side ??   where do changes configration in CUE ??hope some friend can help me , pls tell ...

We have a user running IP Communicator with a Plantronics CS50-USB headset.  They say the volume gets very low over time, both caller and called parties say volume is faint.  We can run the IP Comm. audio tuning wizard and the volume seems to be fine...

Hi All, I have IP Telephony setup with CCME 7.0 and SIP trunk  and I am getting the error as “Cannot complete conference.” When I am trying to make conference with the PSTN Numbers. The sip dial peer used  G729rb8 codec as per the ISP standard. As pe...

I have extension mobility in which the service parimeter is set for auto logout after 9 hours. I want 4 ip phones to be exempted from this rule i.e i want these phones to be logged out by the user not by auto logout. Is there any way to do that.