Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,We have a problem while calling from IP phone to analog and vice versa, it says The call cannot be completed as dialed.Verified no configurations are changed on the voice gateway but we see in logs a serial interface is going up and down for every...
I have read the upgrade procedure (6.X to 7.X) but there is no mention of licences being needed. Do I need to purchase licences?
Hi all,I'm looking to upgrade our CallManager cluster from v6.1(2) to a later version (we have several 'bugs' that later versions allegedly fix). The problem is, there are quite a few versions of CUCM after 6.1(2), and nothing overly obvious on the ...
Hello, How do people make searches in the bulk-speed-dial lists from their IP phone.Best Regards, Wouter
Hi, The E1 connection will "sometimes' freeze for no obvious reason. Once a month, then maybe 2 times a week, then nothing for 2 months. There is no pattern in this freezes. I have configured everything correct. I have used this setup with the same p...
Dear all,I have a strange problem. i've got a pc connected to a alcatel ip phone, which is connected to a cisco 3560. if i remove the pc. and connect an other one, the switch still sees the mac of the first pc. how do I change the setting that the sw...
Does it can be possible?I had found some basic documents to make this integration with CCM using QSIG T1/E1 links and VG248, but I just was advised the customer has CME.Does the CME support QSIG? As VG248 is not supported by CME, VG224 can be used in...
Hi, I tried to configure a cluster in a CCM version 6.1.3 using wizard option, it ask for the publisher name, Ip address and the the security password but it does not work, at the end of the procedure an error was displayed, is there an other way to ...
Hi everyone, i tried to configure TTS but unfortunately i get the following message when i dial the voicemail number from my phone "can't read the message now plz try again later" i checked my TTS service and it's running even my COS is enabled for T...
Senerio;customer is a bank main site hists the CUCM and there are 4 Branches.All of the Branches when calling the Main site have no issues.All of the branches have problems when calling the other branches.Internal calls come across the GRE tunnel. So...
Hi all, I am trying to download the SCCP Software Package for 7912 phones to change logos. I have seen many posts on here with links to the download page, but none seem to work anymore. I have also searched CCO and all i can find is the SIP Software ...
Hi,I have a 3640 router, i want to use as a gateway with 1 nm-hdv-1t1 module and 4 pots. I first configure pots with mgcp, it works, i want to add the nm-hdv-1t1 and it fail to register. may i use 2 nm module with mgcp or it will be easier with h-3...
We use CCM 6.0.1 I have a directory number that if they do not answer or are the phone the destination number is a cell phone. The DN rings six times before it cuts over to the cell phone. Is there some way to change the number of rings before the ca...
Are there any suggested traps to configure on a cisco CUBE router for SIP?We have an alerting system that will alert via SNMP and I would like to configure SNMP to alert us if the DSP resources are getting maxed out or if calls are dropping.Is there ...
I've seen reference to this problem before, but I haven't seen a solution. When I enable Audio Alerts within Attendant Console, I only hear the first quarter second of the audio, whether it's the standard audio file or one that I put in there. Also...
