Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi, i recently joined a company as IT engineer, unfortunately i dont have that much information about Cisco IP telephoney and call manager... i went through the quick start guide that came with cisco2811 but was not able to log into the router..not t...
HiIs it possible to have incoming/ougoing voice calls on an E1 link and also accept inbound modem calls on a voice gateway.?
I have a route pattern where apparently in the called party transformation I need to send the string digit by digit.Our VG is connected by QSIG to an Alcatel 4400.Is there any way to send digit by digit instead of the whole string as a packet?Thanks
Hi Guys,I have a problem on a new setup with incoming calls not ringing through to the phone.My dial peers are being matched and i`m using translation patterns to convert from 6-5 digits.Gateway is H323.So is there a way of checking where the breakdo...
Hi,I have a UC500. Besides going to the web interface for CCME/CUE and going to Reports - Call History, how can I see what calls are being made on the system? How far back does this data go?Thanks for your help!Scott
I have recently configured a CCME and when the users call outside the number being displayed to the other party is our pilot number instead of the indivudal extension numbers...What I mean is that if a user calls outside from a extension 115 the othe...
Hi.I have a cluster CCM 5.x (1 publisher and 1 subscriber)CDR is run in both servers.I think that just the publisher write the bills. But if the publisher's down. The subscriber have a capability of write de bills?Thanks
How do I setup my phones so that users can get an outside operator. When I say outside operator I mean at&t operator.Thanks
is there a way in ccm 6.1, to run reports on individual users that setup new phones and users in the system?
It is taking too long according to my client for 911 calls to complete. CM6 Business edition is at main site in ROchester. The 2 remote sites are having the same problems. We are running H323. I assume the problem is on the gateway, possibly dial...
Quick Q for the Guru's out there.If I have a CME chassis that is maxed out with the number of ephones it can have (52 on a 2821 for example) and I needed to add more phones, couldn't i just add another Chassis with a different Extension range and hav...
how do you factory reset a 79XX ip phone to
Is there anyway to run a report to get a list of users that are not associated with a phone or users that are associated to more then one phone?
I`m using TP`s to configure the cluster- all my internal calls go to the TP against a Specific Pattern and get routed correctly however there is a delay going through the TP`s - is there a setting which decreases it - by default the Urget is ticked a...
Hello,Is there a way to configure multiple instances of the same route pattern digits? We have a PA system in each location and currently with the legacy PBXs, staff would dial 11 to make a page call. Now that we are converting each location to cis...
