Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Is a certain amount of "slip seconds" on a PRI normal and if so what is considered a normal amount?
Hello everybody!I'm to set up a banch office in the UK with Cisco 1800 as a voicegateway (h323) to interact with CUCM 6.0!Outbound calls are working but inbound ones get dropped. The output of debug isdn q931 is "Network out of order". I can ping CUC...
Hello:When adding E1 PRI for UK using MGCP what would be the PRI protocol type?Thanks
I just found out that one of my redundant PRIs is in spoof mode but I did not get a rtmt alert. Since it is redundant, I did not catch this for a couple of days.#sh int s0/0/0:23Serial0/0/0:23 is up, line protocol is up (spoofing)Per doc, the current...
What is the way to check the CUE service engine logs to see if the module had restarted ? ( something like sh version)..What are the possible causes of a CUE module rebooting on it's own even when the router hosting it didn't go down?Any insights wil...
ScenarioUS sideUCM6.0 >> h323 gateway mpls/WAN connection to EuropeEurope sideTashiba PBX >> cisco h323 gateway connection to mpls/WAN connection to USIf both US and Europe h323 gateways have an IOS that support h323 version 2, will we be able to pro...
Hi All,We have a CCM 5.1.3 cluster (with a publisher and 2 subscribers) and a Cisco IPCCX 5.0.2. Also, we have LDAP integration and authentication with AD.We currently run the Cisco AXL Web Service only on the publisher as per the CCM best practices ...
Hi,Does the UC520 support night service?Thanks
Hi,Need help on how to read crash dump files from Communication manager 5.1.3.Thanks,Vinay
Hi,I folled the instructions ('Deploying Dial Plan for 5.0(1) and later releases' to install the latest UK dial plan (dp-ffr.2-1-7.GB.cop) on CUCM 6.1.2.Show software verifies that the COP file has been installed.Problem is that it does not show as ...
Hi all, I have end to end g729 setup.When i answered the call from pstn and i put the call on hold.when i unhold the call the caller wont able to hear anything,but i am able to hear properly.the gateway is h.323.Thanks,gnan.
HiHaving issues with 7970 and 7945 color IP phones.Last week I found that 7970 phones were taking long time to re-register (more than 10 minutes) when I restarted them from CUCM 4.1 (even longer when I reset the phone). No issues when I tested with a...
Hi All,I've installed 3911 sip ip phone whit a CUCM 6.1.2 and when I try to forward call from the phone doesn't work. The phone display say that the phone is forwarded but when I call the original number no ring.Thanks in advance for your helpMscaraW...
Hi, I am trying to configure a isdn pri. I have a 2851 with a VWIC2-1MFT-T1/E1 card. The Telco end-equipment is an Adtran Express 6500 series (I think is the 6540 model, with a RJ-45 G.703 interface). After the config the layer 1 status shows as "Dea...
Hi,I just want to know if will be any issues with adding/deleting users on the secondary unity server while it is active and the primary is inactive.I have got a customer whose primary server is inactive at the moment and wont be able to failback to ...
