Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
The publisher and all subscribers have the Max Records field set to 1500000 records and yet the CallDetailRecord table is currently holding 9670938 rows. The oldest entry is not being purged at night either.The Maintenance Time is set to 24 and Main...
Is it possible to offload the CCM End User options page onto a seperate server?
Can I enable MLA on Callmanager that connected with IPCC and IVR?
I configured the "max-conn" parameter on my H323 voice gateway (see "dial-peer" here below).When the maximum number of calls is reached, the calling party receives the "out of order" tone.Is it possile to configure something so he would receive the "...
Hello, Let's say first and foremost, I'm not a voice guy. I'm trying to get a voip lab setup and I'm having strange issues. I have CCM 4.1(3)sr4d with an IP Communicator soft phone and a 7961 IP phone. The out side connection is a SIP trunk provi...
I am trying to trunk an asterisk and CCM 5.1 to each other. Inbound from the asterisk works, however outbound to the from CCM to asterisk does not :(. I was trying a normal route pattern and now I see SIP Route Pattern. WHen I try to add a SIP Rout...
Hi, I've specced this up for a customer. I've also added a VWIC2-1MFT-T1/E1= . I dont need to order any DSP's do I? ie they should come as part of the bundle surley?
I have CME 4.2 12.4-11.XW6ATA ver. ATA030100SCCP040211A.zupGroup Pickup **4(group #)with Stationary ATA phone works O.K.Group Pickup **4(group #)with DECT ATA phone DOESNT work.Pickup **3(dn #)with Stationary ATA phone DOESNT work.Pickup **3(dn #)wit...
I use external call forward all. If the number I'm forward to is busy, is there a way to transfert the call back to Unity?
How can a user send a message to a group of 30 people using Unity Connection 2.0.1
looking for a way to transfer a call to another subscribers vm directly without ringing the phone. thanks for any help
I've had users indicate to me that MOH is not playing when they are during assisted/warm transfers, conference call initiation, etc. All users have dual-line DN'sSo, Basically, whenever you are putting an active call on "hold" (not actually using th...
Hi; I have a problem in integrating unity express (AIM) 2.3.1 installed in 3845 router with 12.4XY1 release, with CCM 5.0(4) server, what is the recommended gateway to be running between the CCM & the router? I tried SIP trunk with no use and H.323 ...
Hi,I have a phone connected to 2-port FXS card on ISR 2821 router.this router is registered to CCM 6.0.I selected SCCP while adding this voice router to the CCM.The problem is there is no dial-tone on the analogue phone connected to fxs port.Hence we...
HiI am having problems with a T1 circuit (ESF, B8ZS and E&M Winkstart) and CallManager 4.2.controller T1 1/0 framing esf linecode b8zs ds0-group 0 timeslots 1-24 type e&m-wink-start!This is terminating on a 2621XM with a NM-HDV.I can successfully mak...
| User | Count |
|---|---|
| 9 | |
| 4 | |
| 3 | |
| 1 | |
| 1 |
