Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I have a site with two routers (voice gateways) with an ISDN PRI connected to each of them. I had one of the PRIs working for 2 months (connected to one gateway) and recently we have added the second PRI (on the second gateway). IP vice, the gateways...
I have a H.323 Gateway with a fax machine connected to a fxs card. I can receive calls, but cannot call outbound to the PSTN. I can call IP Phones, just nothing to the PSTN. I have tried several different dial-peers. Is there something needed to allo...
Hi,Configuration:--------------CCM 4.1(3)Cisco 2851 as VoIP gateway.Hunt pilot: 1234567 -> HuntList: HL1234567 -> LineGroup: LG1234567 with 1 member - IP phone num. 5004.This IP phone is CallForwarded to the external PSTN number 7654321.What I need t...
Hi Friends,I've just completed installing cm5 on a MCS 7815 server, the server is not connected to any network just stand alone for staging purposes. However, I noticed when I start configuring the system configs, ie, ccm system config, server, group...
When an EM user is logged out, a calling user hears the busy tone, so the caller believes the user is unavailable and tries later. Is there a way of providing a different message/tone for a logged out user? For EM users who have VoiceMail this is les...
Hi! When using in-line power for ip tel, what power does phone need for normal working?Is it 7 watts, 15, or...thx
HiCM 4.1 - In CDR, how do I find the call volume for CTI routepoint per month (ie CTI RP is 34300 and I am looking in in January and February compared to prior months)
Hi. As I can make to communicate iptel's that are registered the same CCM but they don't have permission to arrive from a telephone until another in the net. Can one make that the call passes through of the CCM? . The telephones use the same codec...
See attachment please.Any pointers on what I need to trace and how to, because I am a newee to IP Telephony.I have just started to prepare for CCVP last week.
Hello all, I am working with a 3845 and would like to deliver calls received by the router from a sip proxy through the router via dial-peer statements which use voice over frame. Is this possible?Should this just work or do I need to configure some...
Ok - I've searched google for a few hours before posting this and hadn't found the information I needed, so I figured I'd ask the gurus over here.Basically, I have a small office with 8 phones and 2 have the 7914 expansion card on them, and I'm using...
dear sir, We hope to delete the file located on the extension folder since the drive space left 700mb only. Please advise any tools/command to delete those unnessary file for free up some space on C: & M drive? Please refer to the attachment. It ex...
I have voice gateways with pri e1 connection.We are getting did service.Voip dial-peer is pointing to a 3rt part sip server and it will go to callcenter.When i dial from my mobile to this pri number ,it goes to sip then when sip server redirect this ...
I see that 12.4(11)T supports CME4.0 and IPv6. Does CME support IPv6?Thanks!
Hi, I have Xmedius FAX express Edition T.38 , I have cisco gateway as H.323, can anyone show me a dial-peer or IOS configuration, I have E1 for call at outside.Thanks
