IP Telephony and Phones

Hi,Whats the easiet way of telling which server is a subscriber and which is a publisher?Many thanks in advance!!

Can anyone tell me what this error message is talking about?Directory connection failed .Monitored precanned object has value of 0.

Hi,design is simple: mgcy gateway which has PRI line, ccm 4.1.3 and ata186 everthing is ok except sending fax. i am tyring to send fax to pstn but most of the time i got fail.which settings should be for ata audio mode: 0015 , 0012, 0035 ?which se...

Hi,We are running Unity4.0(5), in the application event I am getting the below mentioned error:EVT_AVMIUMSG_PORT_STUCKID: 584Source: CiscoUnity_MiuMessage: Port %1 has been busy since %2. The system threshold is %3 minutes, indicating that this port ...

When a user goes to the Corporate Directory and hits a single letter say "S" for firstname and then searches, there is an errorError XML Error [4]: Parse ErrorIt seems to only affect 7961, 7941 but I'm still testing with 7970's and 7971. IP communica...

Need some help on this one. It seems I have a user that gets a voice mail and MWI will light. It will stay lit for about 20 seconds and then it goes out. I think somehow Outlook is marking them read without the user reading them. Any suggestions ...

Hey all. I am trying to figuar out why I can not get caller ID to apper on my 79XX phones from an FXO card\port? I have Caller ID enabled from the phone company and enabled in the IOS per port.

Hi, In either a CCM4.X or 5.x environment, connecting to E1's with 30 channel, can the E1 be split in the following way?finance channel 1-5admin channel 6-10IT channel 10-21users channel 22-30 I know it's possible with CME using trunk-groups, how ...

Does any one have solution on record a phone (session)discussion/conversation. Do we need a external tape recorder or Call manager can store a wav file?

Hi,I have one router 2851 ios 12.4(11)T and working with SRST v4.0 connected to PSTN. I have one ata 186 (SCCP version 3.02.01(050429A)but i can?t receive faxes from PSTN . In config guide say "For ATAs that are registered to a Cisco Unified SRST sys...

Hello,I have an BRI MGCP gateway configured, on a 2811, with backhauling of BRI messages to CM5.When I get an incoming call, it shows up as 23XXXXXXXX.I want to be able to present this to the end user as 8023XXXXXXXX.However, I want to do this for on...

Hi All,I would like to know how to reset IP Phone to default factory. Is it the same to all Cisco IP Phone? I have 7911G, 7912G, 7941, and 7961. Thanks very much for your help.

Hello,Please can someone help. I am configuring Cisco 3560's to support Nortel phones. I have configured ports to be switchport mode dynamic desirable and have configured both a voice and access vlan as per below:interface range FastEthernet0/1 - 23 ...

Hi,I have a branch office connected to the central office using a PPP link. There is a CCM in the central site (3.3.4 sr2) and ip phones in the branch office.Using additional DSP on the Gateway of the Remote Office (Cisco1760) I've configured the CFB...