On CUCM 10.x, if I only have the 2 built-in software bridges on the Pub and Sub, what are my limitations on ad hoc conference calls? I know the service parameter maxes out at 64, but is that 64 people on 1 call? A total of 64 people in any combinat...
Hi,Have a couple of Cisco 7942G phones configured with Extension Mobility to CME running on a Cisco 4331 Router. The phones register onto the CME without any issues.The problem I am having is that they don't log in and out cleanly. They log in and ou...
I have a site where my phones will not make a call when I send the information digit by digit but they do work when it is En Block. If I pick up the receiver and dial a number when I am done it just sits there and never seems to do anything. If I d...
Hello Team,
I have CUCM (11.5) connected to a CUBE (2921) and SIP trunk to ITSP, but my inbound calls are not going through the sip trunk while the outbound calls are not working at all.
All the partition and CSS are configured correctly but am unabl...
Hello,I recently was given a few 8861's from a decommissioned site at work. They are 3PCC models which were previously connected to Broadworks.All devices were removed from Broadworks, but they still "call home" after factory reset and pull down a pr...
Hi All,at this moment I 'm in the middle of a rollout of Voip in Vienna (Austria).Everything works fine except one thing.In Austria you can dial to the main to the main number without dialling the 00As example if you call a user you will dial locally...
Hello everyone, so its 2024 and yes I still have the 7941s.Somehow they were stuck on upgrading and getting a 0 IP address even from the router/switch or the PC port. I somehow got it to hard reset using (3491672850*#). Now 4 out of 5 devices keep bl...
Hi guys,In a call between internal user " managed by CUCM " and external user " PSTN ", what is the corrects diagrame representing the call legs :1- internal -User <--> CUCM <--> Gateway <--> external-user OR, ...
If rel1xx disabled then response to 2OO OK msg, ACK msg will go via UDP ONLY?,I am facing the issue where my cube send ACK msg over TCP obly when rel1xx is enabled but when i disable the rel1XX then it always choose transport udp.can someone check an...
I am having an issue with a Cisco 7941G-GE (SCCP) not booting after a reset. I got a report of a PC not able to connect through a phone that has been in service. I swapped out cabling and tried a couple of, known good, laptops so I am fairly confid...
hi all,i am asking about the following:-- auto enable DND feature when you are already in Microsoft team meeting and auto disable it when you finish- auto forward calls to voice mail if you are enable DND- set time for DND , i mean if i enabled it , ...
Hi all,I discovered a strange issue today. Some calls when put on hold, cannot be resumed and just drop. The error code is 65.I have captured logs of one call here: INVITE sip:399054336@103.149.14.247:5060 SIP/2.0
Via: SIP/2.0/UDP 103.149.31.4:5060;...
