Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Whenever I attempt to run Cisco IP Communicator 8.6.6 it has had a more than 50% chance to simply crash and give Blue Screen of Death It gives APC_INDEX_MISMATCH as the bug check string. This occurs whether it is the first program opened after r...
Hi, Need a little help with a route pattern if I may. Some info: CUCM 11.5.1 No transaltion patterns All patterns below are in the same partition We have the following route pattern for calls when dialing full 10 digits with area codes 02, 03, 07...
I have a new Cisco Phone system, we are using CUCM and at this particular site have a 4321 ISR . The fax line is plugged into port 0/2/0. Inbound faxes come through but when sending outbound faxes it rings one time then cuts out. On the receiving end...
Hi, I have a cluster of 2 ISE v2.3 nodes, in my location we don't have an internal CA in order to generate the certificate that we can use for the user authentication using EAP. I was thinking if we can use the Root CA feature that ISE has in ord...
Hello , we found this warning message that DNS is unreachable on the publisher CUCM GUI. My version of CUCM 11.5.1.10000-6.When I tried to resolve some hostnames from both CUCM nodes through CLI it was normally worked so DNS is not unreachable.we ru...
Hello every one i have issue in DTMF between the Cucm And Quescom GSM Gateway when i use webex call me option the call out from the quescom gateway and i resived it in Cell phone but the When i press 1 the webex didn't not responed i think it probl...
I have 3 routers in my test bid, Can some body assist me building SIP PSTN lab. I
Hi Everyone, It really confusing me, what is the use of device pool under the media resources (MTP, CFB, Xcode...etc)?. Hopefully someone can help me. Thank you.
We currently have unity connection 10.x and looking to add another unity cluster due to the size of our business however we do not wish to create another external access numbers for travellers. We can create separate VM profiles and then route to th...
we are using CUCM 8.6we have a route pattern set up for local 7 digit numbers: [5-9]XXXXXXwe also have internal 4 digit DNs which start with 9when dialing the internal DNs there is a delay because of inter-digit timeouthow can i fix this , isaw somth...
Hello everyone,I am new to this forum and I have an issue with calling analog phones which have been configured using MGCP. I have a 2621XM router with voice enabled ios 12.4. my cisco ip phones have been connected using 2950 series switch which is c...
Phone 7821 when I receive a call appears a window with connection, how to not to appear this window and the connection to enter the same screen?
Hello, I am having CME 11.5 on router 2911 when I write any debug command to examine a call ,it says that the debug is on but there is nothing appear although the call is operating and changes occur What shall I do ?
You have been assigned an IP address and subnet mask: 192.168.111.0 /24. Develop a subnet scheme using this address that will allow you to support two subnets of up to 30 clients each, and allow for growth to as many as 6 subnets in the future. Subne...
Hi ive been reviewing the guide to fork audio calls using CUBE however I need clarification on the following scenario. There are plenty of examples of configuring cube forking on inbound dial peers however none on recording outbound calls.Is it possi...
