IP Telephony and Phones

Dears, I get the attached error  whenever I browse to  the CDR page, the CDR were stopped internally by sending to the billing system when I restart the CDR service it started sending to the billing system but the no's of error records and data recor...

Cannot select CUCME for IP Telephony in CCP. I'm running Version 2.8 of CCP, I have a 2621XM Router. Any thoughts?

Hi All, i have th problem in the call called the number is addeed in my call called for exemple. Called call :phone number  0661479638 to number interne 0537543175. but in the IPPHONE i see the my number 00661479638. i need to assit me to resolve thi...

Hi,   I am wandering if there is an option for time based routing on Cisco 2800 CUBE Voice Gateway configuration?   We currently have such device configured between telecom and our internal telephony. What we need to accomplish is to route calls out ...

Hi,   I have a problem with 2 IP Phones 8845 connected to 2 routers with cme using SIP. There is definitely something missing from the dial-peer configuration, but I can not figure out what is missing. Previously it worked, but I made some changes an...

Hi,   I'm facing this issue right now. Is anyone of you can help me to solve the issue? So, I'm going to make a call. Below is the flow:   IP Phone -> CUCM (Trunk) -> VG -> ITSP -> My phone.   Also, please help me guys to understand the flow of How S...

Hi all,   I've got a Cisco 2621XM Router (purchased per the suggestion of CBTNuggets) that I'm trying to use in my home lab. I'm to the point where CCP can discover my router, but I get this far to find that my router isn't supported any further. I'm...

CUCM 11.5 - I have 150 Dx80s CE ver. I have 2 numbers that I want to add to Favorites on all of them. The numbers are in the Directory and I know I can use the Web interface to mark them as a favorite that way, one by one. I was trying to think of a ...

i have hard time trying to make CUBE send 180 Ringing with SDP after receiving it from my softswitch  but CUBE coverts 180 w/SDP to 183 session in progress w/SDP, this cause some callers from ITSPs and PSTN  ( calling inbound ) not hearing Ring tone ...

Hello,   i am configuring voice-gateways since a while. But the change from 29xx to 43xx routers drives me cracy ... newest issue, i can not get music on hold to work to the PSTN.   Situation is like this: CUCM 10.5.2 -> SIP trunk (no MTP) -> 4321 ro...

Hi. Is there a way to configure phones with different time zones in CUCME? Lets say I have some phones in UK and some phones in USA registered in the same CUCME. Thank you.

Hello, I am trying to install cue on ism and receiving the below output ending in error.  I have tried this on 2 different ism and 2 different 2901 routers and get the same result, this leads me to believe that I am missing something.  I have been ba...