Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello there, We are experiencing an issue with softkey position in 8821 phones. We send a text message with a softkey on 1st position using CiscoIpPhoneText XML. Even though softkey is supposed to show in left most softkey position, it shows in the o...
Hi MOH is working only for external calls and its not working for internal calls.I already tried by creating a separate MOH group for internal calls.It gives following logs when call is triggered and put on hold. am using same music file for both mo...
Hi,I have recently migrated a cluster from 6.1 to 10.5.1.10000-7. Old cluster is secure cluster. New cluster is non-secure. Before migrating phonesI have change all the phones to non-secure and registered with old cluster. When I moved to new cluster...
Dears,I have 8831 and CMEThis ip phone has extension 100 I want to allow this phone to recieve more than one call concurrent , not one call active and the second on hold , i want make all call active , like conference but for incoming call
Hi All I have Cisco Router 2951 running IOS Version 15.4(3)M3 with CME Version 10.5 and IP Phones 7821 with firmware sip78xx.12-0-1-8 .all phones don't show any missed call on the screen .
Hi, I configured PLAR (hotdial) on phone 7940, and want to cancel it how I can do that?
We have an existing Cisco Unified Communications Manager Express 9.1 system installed (Cisco 2921 router) and I have a need to shift one of the analog extensions off our VG224 analog gateway to a separate ATA. We have existing ATA186 units attached t...
Dear AllI would really appreciate it if someone could help me out with this issue, so thanking you guys in advance. I have two CUCM clusters(ver 10.5) and sftp. Both CUCM shows scheduled backup end with error " TAR FILE NOT CREATED".If I use manual ...
Hello all,I am deploying a audio ringer and need to add its extension to a ring group so it rings when another phone rings. Scenario: Phone with extension 3136, and audio ringer is 1234 How do I have both extensions ring when a call is made to 3136? ...
Hello everyone,I'll try my best to explain what I need help with and what the peers 'might' be to give you a better Idea.I have two AS5400 GW, I need voice calls (a block of DID's) to hit a dial-peer and then to a trunk-group peer that will send the ...
I'm curious if any of you have some type of routine schedule for rebooting servers and phones ? Be it Cucm, Cuc, Im&p, phone devices. Mine pretty much run until there is an issue and then get rebooted.
Hi, Is it possible to give 2 different time of the day to remote destination schedule.We have a requirement where in the user's cellphone should only ring during non-business hours when his extn is called. For eg, the cellphone should not ring from 9...
Hi, I am having my CUCM server in British Summer Timezone and I have a site in Switzerland which is in Central European summer Time.I was searching for a call in RTMT Realtime data with the time of the call (for eg, 4.10pm in CEST) by selcting the ti...
Hi all,I have a quick question for the community. I have to perform an upgrade for my customer. They have old 7825H2 and H3 servers which are currently running CUCM 7.0.1 (approx 3-4 years old)New hardware has been purchased by them and we have been ...
Hi All, Please let me the the step by step process to upgrade cucm 7.x to 9.x Thanks !
