Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi all,As i understand that IPv4 may run out as early as nxt mth. And we may need to use IPv6. Hence i would like to know if the following devices support IPv6.1)cisco asa 5510/55052)cisco pix 515e3)cisco 28114)cisco 1811/18415)cisco 8376)cisco 1720H...

donnie by Level 1
  • 2630 Views
  • 3 replies
  • 0 Helpful votes

Hi there,Anybody has an EEM applet script for ISDN status? let's say if ISDN layer-1 Deactivated or Fail, sends email alert immediately? Thanks !Global ISDN Switchtype = primary-5essISDN Serial1/0:23 interface        dsl 0, interface ISDN Switchtype ...

I want to update one line of acl on my routers what is the best and easy way to do that . I am thinking running compliance job and update the config or setup rme adhoc job. here the current configinterface FastEthernet0/0.100ip access-group Marketing...

We're using LMS3.2 and are about to change the naming conventions of our switches and routers.The new naming convention will consist of 30 alphanumeric characters.Will this cause a problem with LMS or any of the modules (CS, RME, DFM, etc)?I can find...

BlueyVIII by Level 1
  • 3007 Views
  • 5 replies
  • 0 Helpful votes

I was wondering if anyone could maybe point me to where it states that access levels cisco works needs. We have some core switches that we only want cisco works to store log and configuration settings, but not necessarily allow it to access to change...

fredareid by Level 1
  • 766 Views
  • 5 replies
  • 0 Helpful votes

hi,im doing dns migration from one set of servers to other set of servers.dns takes about 24 hrs for TLDs(com. etc) zones and about 48 to 72 hrs for gTLDs(co.uk etc.). to avoid any kind of outage during this time - can I leave both servers as authora...

gavin han by Level 1
  • 683 Views
  • 1 replies
  • 0 Helpful votes

Hello,I want to intall CSCsx09107 patch, as prerequisite is necessary to install open ssl but the url doesn't workPrerequisites--------------Before installing this patch on Common Services 3.0.5, 3.0.6, 3.1, and 3.1.1, you must install OpenSSL 0.9.71...

j-fragoso by Level 1
  • 1315 Views
  • 6 replies
  • 0 Helpful votes

Guys,I'm getting this message from a specific Access Point.Message: AuthenticationFailure : sysUpTime.0: 7 days, 11 hours, 51 minutes, 11 seconds. , snmpTrapOID.0: .1.3.6.1.4.1.9.9.43.2.0.1 , .1.3.6.1.4.1.9.9.43.1.1.6.1.3.17: 1 , .1.3.6.1.4.1.9.9.43....