I have two Catalyst 6880X-LE which I would like to VSS-Cluster.Is this possible by connecting two 10GiB/s Links and combining them into an etherchannel?Or do I need a special cable,Thanks in advance,Lorenz
Forum Posts
I have been searching for an answer for hours but no one seems to know.You can find similar questions here :https://community.cisco.com/t5/switching/ios-backup-procedure-for-cisco-3850-12s-s/td-p/2980373https://community.cisco.com/t5/switching/how-to...
Resolved! BGP egress traffic not sent to neighbour
Hello, I am trying to set up a bgp multihomed configuration with 2 ISPs but I am struggling to get it to work. I am trying to get it to always use the shortest path available between the 2 connections. My problem is that whichever neighbour is second...
Hello, Please advise, it's possible to create Redundancy (VSS ) between the cisco 4503 and cisco 9403 switches.
Resolved! Using SecureCRT for TFTP
Hello,Currently I'm trying to push IOS images to Cisco Catalyst 9300s via SecureCRT's built-in TFTP feature. Whenever I try sending the .bin file via "send xmodem" I get the following error switch: Transferring , errors 1... Press Ctrl+C to...
I have to pre-configure a C9200-24T-E. It will have C9200-NM-4X installed in it.I am not sure which SFP modules will be used 1Gig or 10 Gig.Can I configure interface GigabitEthernet1/1/1and interface TenGigabitEthernet1/1/1 with same configuration to...
Hey All,I am looking for some advice on how to configure a redundancy Protocol on Packet tracer for my network and any help is greatly appreciated!I have been tasked with creating a redundant network which operates between 2 buildings. I have chosen ...
Mostly wondering if other have seen similar abnormalities. And if so, what they found as root cause.We upgrade about 125 Cisco 9300-48 stacks switches (minority model in our fleet) from 16.12.2 to 17.3.6. During that upgrade we had ~2% of the switche...
Hello,I need to know switch Cisco 3750 POE 10/100 48 Port can run Hikvission Cameras on it or no.
Resolved! EEM to bounce ports
Hi,I want to use EEM code to bounce ports of two switches, but the code I have bounce only the first switch ports.event manager applet port_bounce authorization bypassevent none sync yes maxrun 240action 0010 set switch "1"action 0020 cli command "en...
How do I confirm the part number for Aironet 2802e access points?
Resolved! How to check the part number?
Dear All,By using CLI, how to check the part number on any CISCO's products?Thanks.Terry
Hi all,Its been sometime for me on the CLI and I started a new role that uses Catalyst 3k 9k and Nexus 9k etc, my last role for 6 years was full Meraki top to bottomIve been tasked with changing the password of 1 specific username on all of our switc...
Hi Guysyesterday i've met something i cannot explain so far. Topology was quite simple: couple of access-switches with mgmt IPs (TACACS, RADIUS, SNMP, SSH, etc) use core 4500x VSS as default gateway (mgmt IPs live in the subnets directly connected to...
I've been trying to SSH to a non-Cisco device physically remote from me. This device seems to have lost its default gateway. We used to be able to reach it remotely via HTTP. I'm trying to SSH to it from a local router.From the local IE 4010 running ...
