Unified Computing System Discussions

Hi,we have a pretty serious issue we are struggling to get to the bottom of. I have had a Cisco TAC case (and have just opened a netapp case) open now for coming close to a week, and we effectively have a UCS environment that is totally down. Luckily...

I've just finished reading the Best Practices in Deploying Cisco Nexus 1000V Series Switches on Cisco UCS B and C Series Cisco UCS Manager Servers document. Near the end there is a section with VSM placement options.None of the options advise placing...

Hi Guys,Just trying to get to the bottom of what this requires to fix.I understand what it''s telling me and I was just going to reset the CIMC but on investigation I am a little confused..It states in the early paragraphs that once the memory is deg...

We currently have a 2 member port-channel from each of our 6248s up to a 6500, with src-dest IP load-balancing policy set on each side. We're running into an issue where 2 particularly busy servers are getting hashed to a single PC member, and that m...

Just configure our c210 box with CIMC Manager. It work for couple of days and the connection just completely went dead on us.We setup with a static IP: 172.16.10.100,with subnet and DG.(we try to change the IP too)We can ping it and log into the CIMC...

Q1 : one processor can not boot ? (Two processors is ok) Q2 : one processor can not detect LSI MegaRAID SAS9266-card? (Two processors is ok) Please help thanks .

We currently have CUPS 8.5.2 and want to enable the compliance feature for IM.  The documentation found on Cisco's website does not explain the proper sizing of a volume/disk for the PostgreSQL database as well as maintenance procedures.  If anyone k...

Hi,Importing of equipment from live UCS to Emulator fails to load and gives the following error"Server Error: code -1: 302 Found" as both http and https are enabled on the live CUCM.Thanks,Javed Koor

We are trying to determine if it is possible to install our Servers running a NICE VoIP recording Application in our Virtual environment on Cisco UCS. We have filtering TAPS installed in our network that provide as an output a copy of the RTP media s...

Is it a requirement for this to work to pull out the local disksif they are present? I am using the "Any configuration". with a local disk present.                  

                   I configured it correcly I believe. The strange thing is that there is only one iSCSi initiator pool. See attachment.so when we configure iSCSi Boot Parameters, there is just ONE IP Address Policy. I think this may be the reason th...

Setup are 2 UCS blades in 2 datacenters 50 miles apart. However the backbone between the 2 is 40 Gigabits. The UCS's are connected with fiber at 10 gigs to a Cisco 3750 switch which is also 10 gigs. The San in one Datacenter is an EMC Isilon and the ...

Hi,Is it possible to configure a vlan for packet&control on etherchannel?does ESXi keep configurations locally which received from VSM? (also does it exist after reboot of ESXi?)

I have a UCS Blade Chasis with 8 Blades.Running iPerf to test transfer speeds between 2 Linux machines and I have speeds upwards of 500 MB/sWhen running iPerf from Windows to Windows ....... or...... Windows to Linux...... my speeds are 20 MB/sWe hav...