IP Telephony and Phones

Resolved! calculating remaining licenses in my cucm???

i was asked by my manager to calculate how many licenses we have left , i think according to the attached picture from the license manager we have four licenses for four users . am i correct? we need licenses for new Jabber users.

Resolved! the point of assigning users to ip phones?

can anyone clarify what is the purpose of assigning users to phones in the cucm when adding a phone?

User cannot connect on phone with extension mobility

Dear experts, we have IP Communicator with Extension mobility. Application Login/logout is working fine. User can Login with his Profile on any Workstation. only one PC with IP Communicator brings error when loggin in "Login ist nicht verfügbar (11)...

Resolved! Arabic Language for Cisco Unity Connection 9.1 (voice mail)

Dear All,I am running cucm 9.1 and cisco unity connection 9.1I need to install the arabic language pack for voice mail.For example the user should listen to the prompt in the arabic language.Please guide me how i can perform this task.I will be very ...

Resolved! Phone Bulk Update fails: "String index out of range: -13"

On CUCM 11.0, I'm getting a "String index out of range: -13" trying to do phone bulk updates. Performing bulk updates to lines or users works fine. I've tried different updates, with & without Apply Config. All the same: Every device reports the abo...

Outbound PSTN calls Issue

Hello, We have a Cisco Call Manager 10.5 running at customer. We are using SIP Gateway for Outbound PSTN calls. Issue: Whenever we make a outbound call from inside to any PSTN number and if that PSTN number is Switched off then we are not hearing S...

seperate voice VLAN require we we are using Lync only

We already integrate Lync & CUCM ...which is working fine... we are planning for setup new site with the user with the Lync access only , before that we had created CSF profile for those new users... does we require to create separate VLAN for Voice ...

Resolved! VoIP Dial Peer Destination Pattern

Hi, I want to ask that I have two site which have telephony services. At the Extension 1, when I press number 1000, it shows the message "To 1" and "Busy". At the Extension 1000, when I press number 1, it shows "Unknown number". So how can I configu...

cisco unity conneciton 8.5 , updating primary and secondary dns ip

we have unity connection 8.5 cluster in production running on mcs 7845 server. we are planning to update the dns on the servers, if we update the dns will it bring the license to grace period, and after the dns update reboot required ? what's the exa...

Resolved! Often IP PHONE in rejected state

Hi all, I am trying to set up our Lab environment, prior to entering in phase production.I've installed CUCM publisher folloing two Subscriber.Also My monitoring platform speaking SNMP notice us that some Phone ( any idea how may phone are) was in cr...

VoIP dial-peer

Hi all, I've got a total N00b question, and inherited this setup... I am very new to telephony so limited experience on this front. I have a Cisco 2921 with a NAME: "VWIC3-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 SubSlot 1", DESC...

CUCM 8.6 console session time out

How do I prevent call manager (8.6) to log me out every 5 minutes?Is there way to change the default session time length?Thanks!

Cisco Prime Collaboration how to dellete Unityconnection node

With PCD discover CUCM and unity, customer needs to migrate CUCM alone, please let me know how to delete unity connection form the discovery.

Resolved! Device Packs and Phone Firmware Releases

Dear All, I need to upgrade the firmware for our 8851 phones to the latest release of 11.0(1) (from version 10-3-1-20) Do I need to upgrade the device pack to the latest version for CUCM 10.5.2 in order to use V11.0(1) for the 8851 phones? Or can I...

CUCM restricted or unrestricted

Hi Friends, I understand the diff b/w restricted and unrestricted versions. List of countries where each of them applies is little confusing for me as per below link. http://www.cisco.com/c/en/us/about/legal/global-export-trade/general-export/contr...

IP Telephony and Phones

Forum Posts

Resolved! calculating remaining licenses in my cucm???

Resolved! the point of assigning users to ip phones?

User cannot connect on phone with extension mobility

Resolved! Arabic Language for Cisco Unity Connection 9.1 (voice mail)

Resolved! Phone Bulk Update fails: "String index out of range: -13"

Outbound PSTN calls Issue

seperate voice VLAN require we we are using Lync only

Resolved! VoIP Dial Peer Destination Pattern

cisco unity conneciton 8.5 , updating primary and secondary dns ip

Resolved! Often IP PHONE in rejected state

VoIP dial-peer

CUCM 8.6 console session time out

Cisco Prime Collaboration how to dellete Unityconnection node

Resolved! Device Packs and Phone Firmware Releases

CUCM restricted or unrestricted

Hearty congratulations to the December Spotlight Award winners!

Renew.cisco.com just got refreshed, and it will make your life easier!

Announcing Resources That Guide You to Success

CUCM sends wrong device ID to Recording System

CDR reports: Request for activity on multiple lines

I get dozens of these alarms on WU, but no errros on controller

Transfer Caller ID and 8800 Line Buttons CME

UCCX upgrading Error encountered: The selected file is not valid.

7861 BLF Phone not showing green idle status.

Voice call flow working just one direction in VOIP CUCM to POTS CME

Cisco 8865 use all feature/session keys as Speed Dial

Common Phone Profile 8841

Cisco MTP resets needed sometimes 2x per week? Is this necessary?