Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I'm struggling with the syntax.Trying to change From: <sip:123456000@10.10.1.1>to From: "Name" <sip:123456000@10.10.1.1>
Hi All,please let me know i want to configure Gateway to pass number with *. how to do this?RegardsPardha
Dear All,Is it a must to have VPN access to configure DVO ? Please HelpBest regardsKennedy
ip phone ---- CME ------ CME ---- ip phone --> Successfulip phone ---- CME ------ CME ---- CUE --> FailIf I change the Codec to G711ulaw, it works fine, successful on both. But if I change it to ILBC, which I want to run on my excessivly low bandw...
Hi,We have CUCM 8.0 cluster(Cluster 1).We have another new CUCM 8.6 cluster(Cluster 2) where we plan to configure only 50 phones.There is an ICT trunk established between cluster 1 & 2. Cluster 1 & 2 are not integrated with active(ADS) or any other d...
I have an issue that just effects one of my remote sites that is on SIP but not the others, it also seems to just effect some of the phones with no disernable pattern on type, or phone settings, I even copied a working phone to rebuild a non working ...
I have the ANI of the caller.I am currently running CUCM 7.15. The caller is calling late at night and absolutely filling up our general voice mail box with racists and other hateful language (every night).I know the blocking statements to make on o...
Hi everyone...Is anybody know where can I find a tech note for a menu answering option in Unity Express.thanks
I am new to paging implementationPaging requires any additional software to integerate?Paging can install in windows 2008 server?How can i send brodcast message to mobile?
Hi,Can anyone suggest what Cisco DTMF method can be configured under the Dial-Peer that will transmit the digits within the g.7xx audio i.e. pure in-band DTMF payload ?Regards,Tiberie
Hi,Have a 2811 that I rec'd via smartnet with the incorrect version of IOS. The exisiting 2811 (router A) has c2800nm-ipvoice-mz.124-24.T.bin and the closest IOS I could find on Cisco's software downlad page is c2800nm-ipvoice-mz.124-24.T2.bin. I'...
Hi,is there a 64-bit TAPI driver for CUCM 10.0 available?ThanksRiccardo
I know this may be basic question but I am stuck at this issue..We shutdown one of our subscriber but we had phone service: ABC with that subscriber IP address.X.X.X.XI went into that phone service ABC and changed the ip address in the link and renam...
Hi All,I'm a newbie in CUCM adminstration. Was searching on implementing FAC but Cisco docs not much making any sense.Can someone guide me how to do this? I basically need 1x IP phone to be able to dial IDD and put FAC on it (if I make sense). The re...
Hi,I use a PRI T1 with SIP Voice Gateway. Whenever i dial an invalid number, the message from telco saying this is invalid is received after 100sec. Is there any way to reduce the time the Telco message is played.
| User | Count |
|---|---|
| 8 | |
| 4 | |
| 3 | |
| 1 | |
| 1 |
