Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I apologize if this is a stupid question, I'm an Avaya voice (cisco data) guy, I'm still learning Cisco voice.I've installed an analog polycom soundstation 2, I can make internal and external calls. However I can only receive one incoming call at at...
Our client is requesting that when a call goes to voicemail and the person that is calling in dials "0" the call goes to the local operator. We do that in CUCM with calling search spaces and partitions. But in unity we have not been able to figure ou...
Hello, Engineers!!I would like a help.Actualy I have a CME release 9.I configured an IP Phone 9971 such as SIP and the same environment I have anothers phone such as SCCP.I would like to know if I can configure a call pick group that I can use for bo...
I'm having an issue with Unity 7.0 .Whenever I click on a call handler to play or record greetings , it asks me if I wanted to install "ActiveX Control" when I click yes , it gives a security warning and prevents me to play or record messages on Unit...
Hi Guys,Is there a way to clear the following message on the server.The Cisco Unity Connection cluster subscriber server has changed to Primary Status (failover has occurred). To review server status for the cluster, go to the Tools > Cluster Manage...
HELLO while installing the Unified Contact Center Express 9 on vmware ESXI5.1 i am getting the attached error the VM config 2 cpu4 gb ram160 gb hddos rhcl5 32bitPlease help
Hiplease a try to install unity connection on Vmware version 8 but the wizard installation just shows me cucm install but when i put the CD on physical server it appearsregards
. This drives me crazy...I learned that when wan link is down or not enough BW, the route list would switch to, for example, PSTN-route group so everything is fine....and then later I read that in centrilazed CUCM (with locations-and not enough BW)) ...
Is there a way to increase the session timeout for the CCMUser pages in CUCM6.1.2
I have an IMP 9.1.1 server configured with CUCM 9.1. Everything seems to be good except that the line status always shows as unknown. Everything is in one presence group. Has anyone seen this? My CUCM gateway on the IMP server is pointing to the ...
Hi all,Would appreciate your advice.We currently run CUCM 7 in parallel with a PABX system. Calls come in over H323 gateways and if the number doesnt exist in Cisco land, the call is forwarded to the PABX.We are looking to migrate to CUCM 9 for the p...
I have 2851 with 20 phonesIOS:12.4(11)XJ4giving the following error:Max Number of Skinny Server sockets exceeded: too many IP phones
The 7906G I have does not boot. It has a blank screen and the Settings light is lit up green. It does not respond to holding the # key while powering on the device. The other 7906 I have boots and the SCCP firmware upgraded fine. Both phones are conn...
Dear Networkers,First, happy new year 2013 We're using CUCM v8.5I would like to know; if the SCCP (Skinny Call Control Protocol) gives me the information about the call ender (who ended the call first).I tried to make several Packet captures using Wi...
Hi there,I've read that 9971s do not support PEAP, but it was a relatively old document. Is there a firmware that now supports PEAP? If not, does anyone know if it's on the horizon?Thanks,Josh
