IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Unity 9.1 VM Greeting

hello all,Do you know if there is a way to get rid of the automatic voice which says "hello" XXXX "please leave a message after the tone"I just want to have message that when diverts to the VM box it has my message and no other "in built" messages.Th...

myxxymoxx by Beginner
  • 3 replies
  • 0 Helpful votes

Resolved! 7921G 2821 CME 4.1

I am new to cisco Voip and trying to set up my 7921G on my 2821 with CME 4.1 . I understand that I need a firmware file that will reside on the router for the phone to download, is this the correct file,  cmterm-7921-sccp.1-4-2.cop.sgn ?Also will SIP...

6945G versus the 7945G

Hi,I've been looking at the 6945G phones. We want Gigabit to the desks,and there is quite a saving as compared to the 7945G phones.Does anyone know what differences there are between these and the 7945G,Are there feartures or services not available o...

Resolved! Error Message : if you'd like to make a call please hang up and dial again

Hello All,Users are getting the message "if you'd like to make a call please hang up and dial again" once they pressed the answer button for inbound UCCE calls. (This is intermitted issue). Below is the call flow. Any idea is much appreciated.FXOs-->...

9971 IP Phone line selection

Hi,IP Phone 9971 is configured with multiple lines.Can IP phone 9971 be configured, so that whenever user dial a number (without lifting headset or pressing speaker button)and press call button always line 1 is selected to make call? Regards,Andy

CUCM Redundancy

Dears,I have two Cisco Call Managers want them to work as redundany for my Cisco IP phones. Essentially I install them as a 1st node server and both are upoloaded with Node and IP phones licenes to ensure hardware/software redundany as per the requir...

alshahiry by Beginner
  • 21 replies
  • 0 Helpful votes

No CDR records

Hi All,Wondering if someone are able to help me. Below is the situation.We have a handset registered with CUCM as extn:2000.This extn has a forward all that get activated after 16:30 everyday.So we had an issue where extn:2000 appeared to be ringing ...

Sound card & VM & BE600

Greeting!I am making a LAB.I am trying to run a VM on BE600, then, install softphone on the VM.The problem is there is no a sound card on the VM, and the softphone can't be installed on the VM.is there a way to install a virtual sound card on the VM?...

Yong Peng by Beginner
  • 3 replies
  • 0 Helpful votes