Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hey All,I've run into a problem. My front desk staff run Attendant Console ver 6.14. They are no longer able to save their speed dial data. It used to work fine. I'm not sure when the problem started but may be related to our upgrade to 7.1.3.Their A...
Dears appreciate help,SIP call preservation call throught the gateway are not preserved to PSTN if we made a call from and IP phone registerd with a subscriber and if the sub. fail during the call the call drops there are know documents that talking ...
Is there an SCCP replacement for the ATA186? I have seen the 187, but that is SIP only. thanks
Hello. I'm about to setup a VoIP in a lab environment using SIP. And I've a few wonderings about how to tackle this.The equipment I've are the following:-Two Cisco 2811 Routers with a few integrated modules such as HWIC-4ESW-POE-Two Cisco IP Phone 79...
Hello everyone,I'm actually trying ton configure a line group on CCM 4.2 and I'm hitting a bug (I supposed but Cisco Bug Tool failled each time).I have selected Broadcase as Distribution Algorithm but all the phone, which have a call pick up group co...
Hi Folks;We have UC520. On Fxs port - Fax Machine is connected.We are faxing without problem. The problem is, when we fax it uses random analog liner.We have 4 analog lines. I want to configure that on outgoing faxes, the fax machine shoud only use f...
Hi All,I am doing an integration of LDAP with CUCM. I have around 11 dc and there is a limitation in LDAP directories in CUCM that maximum 5 LDAP directories can be created. Is there any workarounds for this or can I directly integrate with the fores...
Hello,I have some ATA 187 (firmware: ATA187.9-0-3-0), registered on a CUCM 8.0.3.20000-2.It seems that the hookflash doesn't work, so I can't transfer a phone call (from the analog phone attached to the ATA, to another phone).What's wrong?Best regard...
How to generte a report for Zero Duration Call only In call MAnger 7 knowing that I already enable the zero call duration flag service parameter and sure the CDR Services.
what are sep*.cnf.xml files ?Thank you,Najib K
Hello,is there a way to raise/lower the volume of an IP phone registered on a CME by CLI?Moreover, is it possible to raise/lower the volume of the phone when it estabilishes a call over a SIP trunk?Thanks in advance for your help.Best regards.
Hello,We have here a 7.0(2) CUCM cluster, and now we are trying to change the CDR source to a different one and the page times out. At the end it shows "Connection error - Invalid directory path" but I think that this is not the real problem since th...
How can I create a URL Idle that will shift from one screen of data to another? Like the frist screen would be a logo then after 10 seconds it will automatically shift to calendar then shift again to clock after 20 sec,.. etc etc? What configuration ...
Hello,I'm trying to monitor a specific CTI Route Point of ours.It's attached to a critical UCCE hotline and I'd like to be alerted everytime it have a registering problem.CUCM 6.1.5UCCE 7.5.8I'm looking at RTMT but all I can find is RegisteredOtherDe...
Hi Experts,We have some issues with our ATAs since we migrated our GWs from MGCP to H323.-Line 2 on ATA has issues both inbound and outbound-Instance of not getting dial tone on one or both portsHere're some of the settings:LBR Codec 3AudioM...
