Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi All,I am having a very weired issue when I configure CUCM 8.03 for one of our client. I have everything configured, CUCM, CUE and VG. all tested and working fine.But when I configure dhcp on the core switch for one branch office, I got very strang...
HiI have CUCE (CallManager Express 7.0) running on 2900 router at main site.Branch site IP phones are registered to main site CME across WAN link.Can I have SRST at branch site for main site CME in-case WAN link goes down?or srst is only possible wit...
I'm Trying to add some 7975 sets to our CUCMBE 8.0 and I'm getting "Regestration Rejected: Max Phones". When I look at our license unit report is says that I have 815 units remaining? Any ideas?
helloI want to know that is there any license required for ATA(Analog Telephone Adaptar).how to configure ATA in CUCM?regardsAnkur Tyagi
Hi all,I configured the E1 controller on an H323 gateway but it is not coming up for some reason. It is giving me the error : "Receiver has loss of signal"kindly find attached the config of the router with the errors. The Telco technicians told me th...
Hi EveryoneWe are running CUCM 6.1 cluster on MCS 7835 with over 1800 phones in single site deployment. We have CUCM service activated on both PUB and SUB. In CUCM group setting SUB is the primary. Recommendations from Cisco: “Publisher should not b...
Hi all,I'm working on a CUCM 8 installation with mainly 6921 IP phones. We are using SCCP protocol in this installation but unfortunately these phones do not support SCCP SRST on any version of software.Is it possible to configure a SIP SRST and to u...
Dear Support-Team,Will you tell me the part code of Smart net support pack for year to the cisco 7960 IP phone.Regards,Janardhan
want to upgrade an older CUCME to version 8.5. But the phones firmware is something about 8.2 and cannot direct upgrade to 9.1 firmware. must set to 8.5.2 before. whch CUCME Version in Cisco Download Software Page contains this firmware?In CUCME 7.1....
Is there some way with CM and perhaps an h323 gateway to have a fax and phone with the same numberand have the gateway recognize either a fax call or regular phone call and direct accordingly
Hello everyone,I have UC 520, i want to know about muliple auto attendant. As my customer requierment is they have 2 sepreate numbers one belongs to comapny A and one belongs to comapny B, i want to set up sach a way that if some one calling on comap...
I am having a problem with the caller ID for a Fax machine that is on an h323.The faxmachines are developed only on the router themselves no CUCM or other system.I have tried enabling the caller id and the station-id with no luck.Does someone know th...
We recently migrated from a Nortel BCM ip phone solution to a Cisco solution running callmanager 8.5, we are wondering if we can utilize some of our old Nortel ip Phone 2002 and 2004 handsets with the Cisco Callmanager?
Can anyone tell me if I have bad fxs module if the two busy led's are amber all the time. What would cause the FXS module to be busy all the time?
I have just replaced an IPCC 3.5 server with a brand new UCCX 7.1 server. As with the 3.5 server, I used a workflow to force UCCX to record all inbound calls to the helpdesk queue. Unfortunately, all of the recording sound like they're being record...
