IP Telephony and Phones

Gurus,After upgrading my CUE to the latest version, I had three users whose MWI lights were stuck on, though there were no messages in the mailbox. I had them dial the MWI-off extension, and it does turn the MWI off, but it keeps it off, even if ther...

why the "show ISDN active" and "sh voice call status"shows different number of calls?whats the difference?

A basic question: if a phone happened to be unregistred from the CCM, will the call to this ext goes to its vm? thanks

how we configuare Centralize Directory in ccm 5.2

We have a problem in regestering our CCM 5.0 and the 3845 voice GW router, the CCM shows the router as unregestered with the IP Address, and the router I noticed that I'm not able to show the MGCP endpoints. please how can I verify or point to the pr...

dear sirI m using CCM 5.1.and i have configure URL directory parameters. i can see corporate directory/personal directory option when i press directory button.but when i search user in corporate directory it says no record found.could u plz help me o...

I am getting a QSIG error "PRI5033" I am running CM 6.1 . ANyone seen this or have any ideas?

Hi!I have a CME running, when i call between CIPC at 7960, 7940, or 7971, it's work fine, but when i call between CIPC no sound it's played, for any sidesCIPC Version: 2.1.3CME Version: 4.2any idea?

Running cme 4.1. All systems work well except for one issue. When call inbound from certain area codes, the voice gateway router running cme answers with dialtone. If you then dial a 4 digit extension the call completes successfully. This only ha...

I have CM 6.1 and trying to figure out the way to enable a user to admin the client matter codes and nothing more or at least nothing much more that that. I dont see a role that allows just client matter codes. Anyone know the best approach? I fig...

When outside call comes from analog FXO line to my ATA186 phoneI hear callers sound very lowCaller hears my sound with no problemThere is no problem with IP PHONES 7906-7911-.... 2851 with IOS 12.4(11)XW6CME 4.2ATA ver ATA030100SCCP040211A

I have a little problem I'm trying to work out. I've registered CME to a voip provider using the username of the account, not a number. The problem I'm having is that incoming calls use the username in the SIP URI and not my number. Is there is a ...

I have a customer who has this topology:PBX1--->PBX2--->Digital PIMG-->UnityBoth PBXes are Nortel Meridian 1s and PBX2, which connects to the PIMG, is working fine with Unity. We recently added some phones on PBX1 via some tie lines and Unity will i...

Hello all.I'm running CME 4.2 and am trying to setup a page all broadcast to both IP phones and an overhead speaker by dialing one dn.I've tested both the IP phones and the speaker separately and can dial their specific dn's and get the paging featur...