I created a hunt group with the below configuration. All phones rings when the pilot number is dialed but when the receptionist receive the first call, and another call comes into the pilot number the other phones doesn't receive the next call. Can a...
Forum Posts
Resolved! options for setting outgoing caller ID
Ideally, I would like to be able to set this at the device pool level or using an extension range. For instance, device pool A uses 800.555.1212 and device pool B uses 800.555.1313. Or maybe have extensions 2xxx use 800.555.1212 and extensions 5xxx...
Seeking some advice/input on how best to setup a call center with some particular issues/requirements/restrictions being given to me. VoIP Environment: CUCM 11.0.1 6 IP phones (4x 7975 and 2x 8851, will eventually be 6x 8851.) Have access to additi...
Dear all. We are planning to enable URI dialing and I found following information in Support Forum: https://supportforums.cisco.com/t5/collaboration-voice-and-video/configuring-directory-uri-dialing-for-cisco-jabber-step-by-step/ta-p/3159791 Ther...
Hi I have implemented TEHO for my company that has offices in 4 countries but carrier at two of these countries regularly have issues with their FXO lines, which results with callers getting a busy tone whenever they call a number in one of these co...
When someone calls, the phone displays the full ANI and name, but Finesse only shows the extension or phone number. How can I make Finesse display the Calling Name as well?
I want to be able to federate 2 separate CUCM clusters (different companies), so that IM&P users from each cluster can see each others presence status, make calls and do screen share, in other words act as if they are one cluster. This will be across...
Hi Cisco, With exchange (unified mailbox) deleting an email with a voicemail attached deletes automatically the voicemail in the CUC?
Need to know the default URL Idle parameters for self provisioning. I deleted it and forgot to take a copy and can't find it documented anywhere. Any help would be greatly appreciated!
Resolved! Cisco 8861 3PCC hissing noise
I have just configured a brand new CP-8861-3PCC. First time using one of the 8800 series handsets. Everything works fine, but there is a low hissing noise coming from the speaker on the device. I have seen other posts about a hissing noise on the 8...
hello world, I'm trying to provide configuration file SEP$MACcnf.xml from a tftp server My CP-8831 read the file but still stay not registered. does any one had face to this problem ... regards,
Hi,I have a problem, a ip phone is remains registered in the GW (mode fallback) and in the CCM too. How to remove the ephone register in the GW?
Hello experts, I am running normal SIP Phones 7945 and 7965 on CUCM 8.6. I am trying to use a SBC (SIP based) to do the registration in SRST mode. This SIP SBC is cable of accepting REGISTER request. When the WAN link goes down the IP Phone sends r...
Hi All,My customer has a CUCM 10.5 with Cisco 7942 phones with two lines configured. They are only allowed to forward with the primary line but not the second line. The second line CallFAll button is graded out. Any ideas?
Hi Team, We have an issue with one of of customer, they had fraud call with high duration even until about 7 - 8 hours (on the same time and Phone) The outbound call using FXO, and attached the show run
| User | Count |
|---|---|
| 6 | |
| 2 | |
| 1 | |
| 1 | |
| 1 |
