Hi Everyone,I recently set up a lab in GNS3 to simulate the EIGRP routing protocol, connecting two ISPs across two sites.However, I’m encountering a loopback issue based on the trace outputs (the Config files in attachments).I would appreciate it if ...
I have a Switch that I configured using the console cable. I have now added the Switch to another Switch and configured an uplink. I have gone to the remote desktop and created a putty ssh session to the Switch successfully.Then I am prompted with us...
Our customer is considering purchasing Cisco WSA, and they would like to confirm if the following requirements are feasible with the solution before proceeding. Could someone please provide a quick response to the inquiries below?Is it possible to co...
Hi, When logging to the Cloud SDWAN controller (vmanage).. and while doing some configuration i get frequent (around every 10 minutes) session timeout and i need to re-do the configuration... do i need to set the session timeout ? The below is the u...
IntroductionPrerequisitesFTDv in Azure Design ConsiderationsFTDv in Azure Design ScenariosSingle Group of FTDv firewallsInbound from InternetOutbound from the workloads to the internetE/W traffic inside Azure, or Between Azure and On-premAzure L...
Hello, So, I was migrating very old wireless network devices (WLC 5508 and Ap 3602I) at a customer site. Customer purchased WLC 9800-L-F and C9136I-ROW AP. We decided to use 17.12.3 as the WLC software. The software being marked as Cisco suggested re...
Hi,Let's say you have to migrate L3 device. We all know preparation for this can be very cumbersome to do. I would like to hear your experiences, including:1. What is your thought process when you have to prepare for migration? 2. How do you approach...
Currently my Smart Licensing status of Cisco 9800-L WLC says Licenses in use are lic_9800l_perf(LIC_C9800L_PERF), air-network-advantage(DNA_NWStack) and air-dan-advantage(AIR-DNA-A). What will happen if it expires. Can I continue to use the Cisco 912...
After going through several resources on configuring MAC Authentication Bypass (MAB) with Cisco ISE, I found that it's quite simple. Most of the configuration is done on the switch, with only minimal setup required on ISE for policies and identity ma...
Hi, I am new to Software-Defined Network. Currently upgraded a building of old switches into Catalyst 9K series with still a traditional networking. If implementing SD Access into the traditional networking by using DNA Center, do I have to manually...
Hi there,I want to know the IP pool usages on the Firepower for Remote Access VPN users.From the CLI (via system support diagnostic-cli), I can do:show ip local pool [pool name] The 'ask' is if there is other ways to get this info?Does this info avai...
Welcome to yet another big update of Cisco Catalyst Center! Whether you are a Network Engineer, Security Specialist, DevNet Engineer, or IT Leader, you will find something new and interesting in this release. NX Customer Success Specialist Chiara...