Hello Everyone, Currently using CUCM on-premises version 11. Need to add licenses for users to use Jabber, only one device per user so I was looking for UCL-Enhanced but that is End of Sale since January.Now with FLEX-3, I see we have Named User Enha...
Forum Posts
Gents,Good Day, Look, I have an Ext#777, and it received an External calls by Prima Cell . When I call that extention i have 2 options, first one the person answers and the second is Greeting Message reply if the person did not pick up the Call, thi...
Resolved! CUCM 11.5 COP file not found
Hi guysIm going to upgrade a CUCM 11.5.1.18900-97 to 12.5 using PCD. The guide says I need to install the COP file ciscocm.V11.5.1_CSCvv25961_add_diffie_C0085. But I can not found it, it is not in Cisco Software download page. How can I get it??The g...
Hello Guys, Anyone knows is there any way to crack JTAPI and AXL Password of CUCM. We have forgot the password.
By definition Each Unified CM node can support registration for a maximum of 10,000 endpoints. Each cluster can support configuration and registration for a maximum of 40,000 endpoints. In a CLUSTER with eight nodes running Call Processing, if we cr...
Hello, I have problem with incoming calls from ITSP, the calls rings out on CIPC but answering makes no sense on calling cell phone.here is TranlatorX flow, router's config and debug ccsip message output.! voice service voip allow-connections h323 t...
Resolved! voice class server-group using DNS name
I'm looking to use the voice class server-group command in a CUBE config, and looks like we can only use ipv4 or ipv6 as an address type. Any way I might be able use a DNS name instead? Doesn't look like it. I suppose I could translate it to IP, but ...
I'm trying to record a message on the phone through CUTI, then set it as a greeting using CUPI.When I record, I POST{"op":"RECORD"}to /vmrest/calls/{callId}, which returns the following once I finish recording by pressing # on the called phone{"op":"...
Hi Community, I have a doubt Staff that administers the active directory (LDAP), tells me to make some changes in the parameters of organization units (OU), the service is configured in such a way that users use authentication through LDAP. My questi...
Resolved! Install and configure Jabber manually
Looking to install Jabber manually without UDS for testing.I've looked at some documentation but it only speaks to how to setup UDS but not how to setup and install Jabber without UDS. Just want to enter the information manually or a config file.any...
Can we restore a DRS Backup of CUCM 11.5 on a new CUCM 12.5.1 and vice versa from CUCM 12.5.1 to CUCM 11.5 ?
Hello, We had to do a disaster recovery for the Unity 9x after that we started having the following log errors. Service operational status is DOWN. Connection Access Layer;Connection Diagnostic Portal Service;Connection Directory Feeder;Connection In...
Hi all, We have an IM&P cluster of 2 members in Active-Standby mode. VMs installed with 5k ova. Users increased and we need to go to 10k. Question is do we need to install new VMs with 10k ova or we can just increase vCPU, vRAM and vDisc to the numbe...
Hi! I would like to know further about the port ranges that is required deployment of UC infra.For example:expressway guide, port range 1024-65535 need to open. does this mean you need to open all these ports? or you can select any port number from ...
I was hoping to get some help with this. My boss and I are admittedly completely out of our depth with this Cisco phone cluster. Yesterday our CUCX sub virtual machine powered down for unknown reasons. After I got it back up, I have this inconsistenc...
