Unified Communications Infrastructure

All, The customer was getting a SIP Circuit for the PSTN but will not be ready. We'll use the 2 existing PRI temporary until the SIP network is live. The customer has an Avaya system that will be replaced by CUCM 11.5 and a ISR 4331 as a MGCP gateway...

I am trying to use Self Provisioning  for +E.164 format Primary extensions, when I do that I get an error from the IVR, if I remove the + from the DN the phone provisions fine.  Has any one successfully tried it?  I am running CUCM 11.5 Thanks

Hi pals, I would like to check a scenario that I have purchased SWSS through a Cisco partner for Unity Connection. As there will be a new service provider to support the Unity Connection and going to upgrade the software version, may I know what wil...

Hi, We have successfully installed PCD on our VM and managed to discover cluster but when trying to add ESXi it gives an error stating unable to mount NFS datastore. We have tried all possible ways to get this fixed but in vain. Finally VM engineer ...

Hi all, I a having problems to send notification messages to my email address, but without the wav file, is that supported? When I go to edit --> message actions --> email : I select "Accept and Relay", but I don't want the wav file, then I disable...

So apparently Cobras IMPORT latest version won’t import 1.2 files. It says to use an older version but from where can I get that? Then the next question is what version of Unity Connection must I import it to? I’d imagine older versions of COBRAS won...

hi all, i have one migration which is Cisco unity 7.o installed in windows 2003 server with Active directory now i want to convert that unity to latest 11.5. As per my knowledge version 7.0 is Linux based but when i checked in the server it is showi...

Hi! I have upgraded my callmanager form version 4.1 to 7.1. Everything works fine, but i had on callmanager 4.1 customized .ASP for the corporate director, so i could make the query using first name, last name or Department. After the upgrade, i noti...

I'm trying to set up LDAP synchronization with CUCM (v9.1.2). The problem is CUCM uses base scope instead of sub-tree: conn=1017 op=1 SRCH base="ou=users,dc=xxx" scope=0 deref=3 filter="(telephoneNumber=*)" I can't find if and where can I set scope ...