Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi everyone...Is anybody know where can I find a tech note for a menu answering option in Unity Express.thanks
I am new to paging implementationPaging requires any additional software to integerate?Paging can install in windows 2008 server?How can i send brodcast message to mobile?
Hi,Can anyone suggest what Cisco DTMF method can be configured under the Dial-Peer that will transmit the digits within the g.7xx audio i.e. pure in-band DTMF payload ?Regards,Tiberie
Hi,Have a 2811 that I rec'd via smartnet with the incorrect version of IOS. The exisiting 2811 (router A) has c2800nm-ipvoice-mz.124-24.T.bin and the closest IOS I could find on Cisco's software downlad page is c2800nm-ipvoice-mz.124-24.T2.bin. I'...
Hi,is there a 64-bit TAPI driver for CUCM 10.0 available?ThanksRiccardo
I know this may be basic question but I am stuck at this issue..We shutdown one of our subscriber but we had phone service: ABC with that subscriber IP address.X.X.X.XI went into that phone service ABC and changed the ip address in the link and renam...
Hi All,I'm a newbie in CUCM adminstration. Was searching on implementing FAC but Cisco docs not much making any sense.Can someone guide me how to do this? I basically need 1x IP phone to be able to dial IDD and put FAC on it (if I make sense). The re...
Hi,I use a PRI T1 with SIP Voice Gateway. Whenever i dial an invalid number, the message from telco saying this is invalid is received after 100sec. Is there any way to reduce the time the Telco message is played.
Hello!With CME 10.0 Jabber for Windows 9.1.0 and above is supported in Softphone Mode. I know what to setup on CME to get J4W running, but I don't know how to train J4W Client that it will register with CME. Do I have to setup something in xml config...
Hi,I've been informed that a graceful power down is not needed on IOS devices such as a 3825 voice router and the VG224's. I just want to confirm that this is correct or is there a proper power down command to run from IOS in order to shut down a 38...
Hello there,One of my client is a PA to her manager. On her Cisco 7975 phone, she wants the same line button to act as both shared line and BLF, is that possible?Basically, she wants the both functions below:-1. She wants to be able to pick up that...
Hi,I've got some Cisco 2901 routers configured with VPN tunnels to an ASA5510 (multiple networks on both sides).The tunnel works correctly from network to network. The router itself however can not ping any of the remote networks.If ping from the rou...
Hi All,In our organization we need to route some calls from translation pattern to voice mail and the calss should get land to voice mail and it should promt for the greetings we have recorded.Can some one help me how to record greetings and to ro...
Hi,I'm configuring an h323 gateway that will be receiving 4 digits on a PRI, I have 4 numbers that will be ported, and a new range, that will need to be "massaged". The 4 ported numbers are straight forward, and translations work, but when I'm tryin...
Hi,What part code should be used for US, Is it CP-7925G-A-K9= or CP-7925G-W-K9=?Are there any regulatories or compatibility issues around this?Thanks,Nirmal
