IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! Can not add H323 gateway again

Hi all,I am doing lab with CUCM 7.1. So, I added one h323 gateway ( and then  I deleted it. Now, I add new h323 gateway (same Ip address, one message displays:"Add failed. One of the required fields on the page has the same...

Resolved! New Hunt Pilot for internal number is not working.

Hi support, I have a problem with the new hunt pilot number that created for internal use is not working. I had create 1 internal number (1090) for the Hunt Pilot number, and there are 2 hunt group member (9382 / 9387). These number will forward all ...

Office relocation

Hi All,I have a site relocating from office to another and there will be 3-4 weeks gap, users will work from home using their internet connection and VPN authentication so no issue for this.The issue is from Voice, currently users did call forward fr...

fadyawad1 by Beginner
  • 3 replies
  • 0 Helpful votes

CUBAC Blind Transfer

HiI have installed CUBAC 9 and CCM 8.5All Route points and ports have been configured with a CSS that has access to all endpoints.When I try and do a blind transfer from the console the endpoint rings but when I answer the call just drops.If I do the...

MGCP Gateway and Fax

CUCM - most recent release:CUBE will be on 29xxWe were planning to enable T.38 for Fax on a VG224 analog gateway under MGCP control.  For various reasons we may not be able to use the Carrier we had been planning on that supported T.38 on SIP Trunks,...

NTP server error

Hi AllI have problem in NTP server I configured my Domain server as ntp server when add the ntp server in the cucm 7 Pub by ip of my domain server (  the status showing  "The NTP service not accessible".I login the ssh to the call mamager...

Resolved! CME-BACD

I have a problem . this is the first time to install CME-BACD . when I finshed the instllation there are an error apper :Oct 24 06:55:46.027: //3//TCL :/tcl_PutsObjCmd: TCL AA: +++ B-ACD-SERVICE not registered, Starting B-ACD-SERVICE +++Oct 24 06:55:...

ISDN ds0-groups

Hello, can someone please give me a couple of examples of the purpose for dividing ISDN timeslots up into DS0 groups.Apart from allocating some timeslots to voice and some to data, what other reasons would there be ?Thanks for any help.

fran19422 by Beginner
  • 1 replies
  • 0 Helpful votes