Hello to all.Hope this mail finds all of you well.I have a problem with a CUOM Prime 9.0.The customer's infrastracture is a cluster CUCM (VM), 9.1.2.The CUCM cluster is up and running and all the cisco devices can be discovered.The customer wants to ...
Hi.I have elm and cucm installed on the save virtual host. I want change ntp server address on that host. Do it need to generate net license after tha or not ?
Hello,wondering if there is way in callmanager or in IOS gateways that could generate an email whenever a specific DN is called. the email would just need to contain a timestamp of the call and the calling party number.
Hi All,Have a CUCM 8.6 BE (only Pub) and a Router (c2900-universalk9-mz.SPA.150-1.M6.bin). Both are configured to have SRST, and when accesing "Telephone Information" at IPPhone 6921 active server and inactive server are displayed in right order. Bu...
Hello All,Today, we deleted 2 (24 Buttons) expansion module configuration as per the request from customer, but now he asks us to restore them back.So just want to know is there any possibility to get those configs and restore them...Expecting your r...
dears,I have cisco unified presence 8.5 installed on UCS server and i need to upgreade it to 9.1.1I will upgrade the cucm and unity connection to 9.1.1Please advise what are the steps to upgrade the presence to 9.1.1?Best Reagrds,Haytham
Hi , My voice gateway is directly conected with the switch : interface gi 1/0/22Des -------- connected with Voice Gateway ---------switchport access vlan 20 ( Vlan 20 is Voice Vlan)switchport mode accessRoueter port config :int gi 0/1ip add 1...
On all 9971 phones, when a call comes in, you see the ANI, but when you go to the missed calls or received calls, it shows "unknown number". The cucm version is 8.6 and the firmware load is sip9971.9-2-1 on all phones except for one. That phone was u...
Hi,Is there any way to get more detail from the alerts generated by RTMT. I would like to know what gateway went down but we cannot tell from the messages that are sent from the system.Here is an example of what is recieved when we lose a PRI gateway...
I need to know is there a command to delete the show ephone output for the unregistered phones.R_VOZ_JGS#show ephoneephone-1 Mac: TCP socket:[-1] activeLine:0 UNREGISTEREDmediaActive:0 offhook:0 ringing:0 reset:0 reset_sent:0 paging 0 debug:0IP:0.0.0...
Hi All,I want to upgrade CME 8.0 to CME 9.1 for use CP 3905.I have question CME 8.0 upgrade to CME 9.1. I can't add dn phone type 3905. Cisco Unified CME 9.1 Supported Firmwarehttp://www.cisco.com/en/US/docs/voice_ip_comm/cucme/requirements/guide/c...
