IP Telephony and Phones

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

On this router, there are two ATT PRI's.  No configuration changes have been made on this router.  Every 30 minutes both PRI's go down.  The T1's are up, but Layer 2 goes to TEI=0, Ces=1, SAPI=0,State = Timer_Recovery, then Awaiting _Establishment, t...

Hi,I've trouble making the TSP connection to a CUM 8.6 cluster. I am using windows 7 64 Bit PC and installed the "CiscoTSPx64.exe" as a fresh, did a reboot and configured the required paramenters (CTI Server/Username PWD).When I use dialer.exe, I don...

When customer in Site A place a outbound call, if in the office B transfer that call to other colleague, then in site A can not hear anything.Looking in the configuration of the router with a CME, only have a dial-peer pots so I can not introduce a v...

On my 7915 expansion module one of my speed dials icons is displaying a phone icon w/ an x symbol on top of the phone.Anyone have any quick ideas? Tried power cycling the end users phone but the status symbol stays the same and the light is red.

CUCM 7, I am setting up Mobile Connect and it will ring the cell phone, I can hang up the cell phone and pick up on desk phone, but cannot transer from desk phone to cell phone.  When I press the mobility softkey I get "Mobile Connect Off" "You are n...