IP Telephony and Phones

Hi,i have installed cisco mobile 8.0 on my iphone and when i try to join to the call manager over wireless (using tftp address and id i created on call manager), i am unable to join the call manager. i have included the tftp ip address on the dhcp of...

Hello Sirs,I have tried to find CUCM install DVD for version 7.1.2-10000-16 to recover and upgrade a system, and not able to find.Do you know how to get?thanks

Hello,I have a CUCM 8.6 with 7960 and 7962 Phones.Cisco 7960, Firmware 8.1(2)Cisco 7962, Firmware 9.2(1)If I use the builtin corporate directory with any of the phones, my keyboard layout for the button "2" on the phone is like this: abc2....If I use...

Hi,I was asked to set QoS for LAN for cisco IP Phone. I have checked several reference but is not clear for me which commands must I used in order to warranty QoS. Mainly I know I must setmls qos  (global configuration)for switch's portsSwitch(config...

Dears,We have two geographically far away offices connected by VSAT. In the main office there is CUCM 6.1 cluster and the other office there is CUCME. Intercluster trunk (non-GK) is configured between the CUCM cluster and the remote CUCME. There was ...

Hi we are using CUCM 7.0, and it has been integrated to our directory server. In some of our cisco 7945 phones corporate directory menu is not showing. How and where we can enable this menu ?? can any one please help me ?

Hi all,Is there any bug in new logical partitioning w.r.t border devices? I have assigned a geolocation to 2 ip phones and a voice gw through same device pool and defined a policy like below.Int (India) to border (India) allow but ip phones still not...

I upgraded my CUCM from 4.1 to 8.5.1 and everything worked fine. CUCM 8.5 comes with default phone loads of 9.1SR1  for 7941-61 phones. All 7941-61 phones had below  FW App Load IDJar41sccp.8-2-2ES1.sbnBoot Load ID7961G_64-02070631Amd64megRel.binVers...

Hello all,there is a question which must be very trivial but I'm stuck searching for answer.There is a CCME system connected to PSTN through FXO ports and a few IP phones registered on the CCME system (SCCP protocol is in use). Destination pattern fo...

We have Call Manager  (7.1.5.32900-2) Publisher and two SubscribersJust wanted to know if there is any protocol in rebooting the entire cluster:Is there any order that needs to be followed?It will be after normal business hours, so no one will be aff...

Hi,I would like to ask on the steps on how to configure hotline in CISCO Call Manager 7.1.5.10000-12? I would like to allow certain hotline numbers using maybe a 3 digit or 5 digit that can be called using our ip phones in my office. Thanks!

Hi there,I would like to ask about the CISCO IP Communicator. What are the internet requirements for the CISCO IP Communicator to work? I tried to install this in my officemates' laptop, and was successfully installed but the problem is when I call, ...