Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi peopleI am running the Dirt to 1108 mailboxes (W2k + Unity 4.0.5 + Exchange 2k). On 33 minutes, 869 mailboxes was copied. But on mailbox number 870 (Example Administrator), the copies were slow. Until this record was being used in HD 2gb, after t...
I am forwarding calls that are unanswered from one ext to another which is working fine. The forwarded calls are not going to voicemail on the destination extension. Does an "Alternate Extension" else need to be configured in the SA Web portion to al...
Hi allI am trying to run subscriber reports and I get a message saying that it has queued. When I look in the commserver\reports I cannot see the fileAny ideasThanks
Is there a way to block certain incoming numbers on call manager from getting through to specific DDI's? I know you can do this on the gateway but I want to know if it is possible to do this from within call manager version 4.1(3)Scenario - nuisance ...
Hi,I've changed the IP Address of the Unity Connection Server but it seems the IP Address on the Connection Location page does not change. Does this matter? I am trying to network two Unity Connection servers with the same hostname but in different d...
I have a new install of a CCM 7.0(1) running in a lab on a VMware server. Also installed is a Unity VM 7.0(2) running in VMware. When you dial the VM pilot number (7000) you reach Unity. When the Messages button is pressed on an IP phone this mess...
many people asking about the requirements of the cables to support IPT.So, Is there any recommendation from cisco regarding the cables like:( Do not use IPT and PoE with Cat5 cables)????
Sorry if this has been discussed, but my search only brought up Unity unified messaging posts.I currently have unity 5.0 voicemail only.We recently moved to Exchange 2007, and are licensed for the new "Unified Messaging" feature in Exchange. I am lo...
Hi to all,How can I configure auto attendant with cisco unity connection 7.Best regards,Alberto
We are deploying presence in a UCM 7.0(2) cluster. We have UCM integrated with Microsoft AD (both synchronization and authentication). The only problem were having after completing all integration steps is the voicemail piece to unity connection. ...
Hi to all,How can I disable the "configuring VLAN" on Cisco IP Phone (I've a cisco switch and there's not a VOICE VLAN ... the pc and the IP phone are in the same VLAN)?Which command is avalable on the Cisco switch to speed up the connection of the I...
does anyone know why i am unable to change the contrast on my 7971/7975 phonesall other settings work OK but contrast setting is dimmed and not accessible
Hi, Can some one give a detail in a simple words, on which occasion do we need to install conference bridge ? Can't we have a video conference without a conference bridge between Cisco IP video or in a multi vendor Video IP Phone ?Thnaks
hiI have configed EM function and it worked well,but when I deleted one IP Phone, then add it again,if click the checkbox :Enable Extension Mobility,CCM returns an error message:Update failed. One of the required fields on the page has the same value...
Hi I have CUCM BE 6.1. 2 days back I rebooted the server couple of times for resolving CUP connectivity issues. After doing this I ran into a problem. All the devices (Phones and Gateway end points) status is unknown while they are functioning fine. ...
| User | Count |
|---|---|
| 8 | |
| 4 | |
| 3 | |
| 1 | |
| 1 |
