IP Telephony and Phones

I have heard the call can be recorded without configuration of SPAN in callmanager 6.0, anyone can give me more detail about this feature in CCM6, and how to configure this feature.Thanks

Hi,CME voice gateway 2811 has VIC-4FXS/DID configured as DID trunk. The local teleco said they send us 4 digits, however,we only received the first digit instead of 4-digit for inbound DID calls.IOS version is 12.4(15)T3.signal type is wink-start.Can...

Hello all,I am getting an RTMT alert about our CDR Repository not being backed up. I am wondering though, we have recently began off-loading the CDR to a 3rd party billing application, would this be the cause of what I am seeing here? If so would th...

Hello, I have a UC520 with 2 analog lines going in and about 10 users with 7941s and 7912s. On their old PBX system they had 2 little red lights on each phone that lit-up whenever a line was busy.Now, there doesnt seem to be a way to display if their...

I am running CCM 4.2. I have a facility that uses a 2820 (h323) for outbound cals through a T1. When calls are placed, the router sees the call but it takes 10 seconds before the call rings out. During this time the IP phone says "call proceed. This ...

Does anyone have experience with configuring a single fixed audio source (live stream? The guide is not intuitive enough and currently all users have is silence when placed on hold. The stream is a radio station (company owned). We also cannot tell...

My friend, I have a feel you can help this fellow:http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cbff297Clock "seem...

Hi,We need to telnet to one of the phones to monitor some traffic but we can't telnet to it (192.168.3.53), whenever we try we get the response:C:\>telnet 192.168.3.53Connecting To 192.168.3.53...Could not open connection to the host, on port 23:Conn...

Hi all, I'm looking for advice with using fax / pdq (card processing) machines with call manager express (running on a Cisco 2851 router PRI ISDN 30) over a fairly large geographical area connected by fibre. So using fxs back to the central location ...

We have a client that migrated from CCME to UCM 6.x. They said in CCME they used Call Pickup to retrieve a calln on hold from another person's IP phone. I'm not familiar with this functionality and am looking for a UCM 6.x alternative. I am familiar ...

Hello,I planning to have 10 digit extensions in CUCM I want the users to be able to dial both 10 digit or just last 4 digits of their numbers to call each other? How can this be done, since all the translation rules refer to external calling and not ...

We have several 7931's we are trying to bring on line with auto registration.We reset the phones to factory default and the display shows Upgrading on the right side of the window and at the bottom it shows the MAC.We have reset the phones several ti...

I'm looking for the carrier side SIP trunking capacity of the UC500 product line. Can someone help?Gino

FAX's connected to VG224 receive line error on incoming FAX's. Outbouond FAX's complete successfully. This is an MGCP gateway I will include the MGCP config in this postccm-manager fallback-mgcp ccm-manager redundant-host "Call Manager Publisher"cc...