IP Telephony and Phones

Hi,I want to generate a report from the CDR database. But I've found that the called number column (originalCalledPartyNumber and finalCalledPartyNumber) that is being registered in the database consists of only the last 4 digits of the actual called...

Hi,does any one have a working configuration where the cme has transcoding and conferencing profiles configured using PVDM2i was able to register the transcoding but the conferencing was saying registration failedGood day

Hi guys,i'm experincing some cross talk problem with 7911 on the same vlan of CCM(5.1)Centralized call processing.I have HP switch.any idea?Thanks in advance!ale

I have been experiencing some extreme network latencies recently, so I installed wireshark onto one of my clients.The first thing I noticed is that my 3725 voice gateway was flooding the network with SCCP UDP broadcasts to 239.2.2.2. I was curious i...

Hi,I use CCM6 that use SIP trunk to a Gateway.This Gateway use another H323 trunk to another voice gateway.The schema is :CCM <-SIP<->GatewayA <-H323-> VoiceGatewayBThe two parts can call between them.But The CCM'user cannot transfer really the call ...

HiI have a CME running version 4.0(2) and multicast paging is not working, but unicast is.I suspect it might be a routing issue, but I'm not sure how the process works(message flow between CME and phone) and therefore I don't know where to look first...

Experts,can you tell me which field names or atributes to query for in CDR to get reports on toll bypass usage? i'm also try to get reports for WAN call volume to quantify bandwidth & qos. any insight? thanks....

CME 3.0 7960 IP Phone -dials out no problem shows ring and connect on phone disply but no ring feedback on the handset. How do I enable ring Thanks

Have a UC500 running 4.20. Customer is reporting that sometimes when users play a retrived a voicemail the message plays moh. Now this probably has to do with something the receptionist is doing when she transfers a cal, but I cannot figure out wha...

we are note getting a stable connection at call initialization. We hear one ring on our end, then the call dies. about 30-40 secs later it rings again and we can answer the call. all of the callers say there is dead silence when they dial, they think...

I understand the difference between Disabling/Restricting Settings Access for the phone instruments, however can someone explain to me why we can unlock the menu but then still not gain additional access to what's there? What's the point of unlockin...

Hi. My 7941 connected to my new 2801 ccme system has a dialtone.When I pick up the handset on the 7931 there is no dialtone.When I call the 7931 from the 7941 I get a 'busy' message.Any ideas?

Hi. I've got a new 2801 here and an interface card for it. Now i've got 4 available slots for it, but im sure I read somewhere that if I put this vwic2 card in one of the slots I could damage it.. but I cant find that document now grrrr.What slot sho...

Hi to all,is possible to configure a CME with SIP and SCCP phones?If yes how can I do that?thank a lot.Augusto.

Can anyone explain why, on a new install with no phones configured, the diskspace says it is 93% on the active partition? Is this standard