Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi. We have two call-managers: Pub and Sub. The router can ping both' ip address. and both Pub and Sub are activated already. When showing ccm-manager in the router, we can see Pub ip address, but cannot see Sub ip address. Anyone can give some sugge...
Hello I am looking for a bit of advice, we have a Centralized CUCM and CUC for Voicemail, with CUCME running in SRST mode at the individual sites. There is a requirement to split off some of the sites. I know the CUCME can run the phones and I know ...
HiI have Cisco call manager v 8.6 , recording system which is "speech log" . My problem is all my SCCP phones recod the calls very well , but SIP phones as 9971 has a problem when i try to record , i did not get any log from these type of phones . An...
Hi , We are running on IP Telephony set up with Call manager version 9.1.2 on UCS servers. We have installed cop file for adding the DX 80 IP Phone 6 months before and installed successfully the COP file and after that we got the option to add the...
Hi The command "show isdn status" shows that there is message --- "TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED" in the output. then I use debug isdn q921. but it does not show any reactions regarding isdn. Anyone have any suggestion? The follow...
Hi Pub and Sub are installed and the router can ping both of them. The router can only see the Pub, not Sub when show ccm-manager in the router. What is wrong? Thank you!
Hi After IP phone which had worked well moved to second DHCP pool's subnet, the phone can get ip address from the second DHCP pool. but it cannot register. Then I cleared ip arp etc. but it still cannot register. IP helper-add is also configured. Any...
Hi Two ip phones are at the same subnet work. One phone can get ip address from CUCM, but another phone which used to get ip address cannot get ip address now even after setting to factory configuration. Anyone give some suggestion? Thank you.
Hi, SIP trunk calls are hitting on ivr but unable to collect digits but on PRI tcl digit collect is working. So for sip trunk we tried to use different commands in Incoming dial peer. dial-peer voice 5001 voip translation-profile incoming CALL_IN s...
helloI have problem with cisco 7861 .sometimes in cisco 7861 missing softkey template.after we perform reset the problem solved.any idea?
we have cisco CME v10.5 , i need to monitor 2 fxo ports through sip ip phone 7861 buttons , Could any one help me to get the configuration steps ?
On a CUCM 9 we wanted to add additional Basic licenses. There were two separate orders and two bin files were generated. After uploading the bin files, the basic licenses that were there since the initial installation disappeared as did also Essentia...
Hi, I'm working on the CUCM 8.6. I need to extract the 500 oldest IP phones in my CUCM, can you, guys, show me how to do that ? Thanks in advance, guys.
Hello, is there any a quick and free solution based to add in the CUCM corporate directory ( not the personal directory) entries for outside phone numbers PSTN ( people that are not CUCM users) . Thanks Dan
Gentlemen, can anyone help me configure the IP Phone CP7906G? I do not think anywhere on the Internet a tutorial that teaches clearly set, the account sip nor guidance on how to edit the information on the machine's directory. Who can help me thank y...
