Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
hi all; I need my gateway to route the calls coming from 58XX extensions to PSTN SIP trunkand to route the calles coming from 61XX extension to FXO lines anybody had this scenario befor ?! regards
Hi everybody.quick question for you guys.How much max jitter can we have before our voice call start degrading severly ?Is jitter of 1 msec too much to maintain good quality call ?thanks
SCCP phones can be recorded but Cisco SIP phones cannot be recorded in our environment which uses port mirroring in the switch.
Hi, I have an UC560 with external SIP lines an a couple of phones on the inside.The problem is when i receive an external call and i want to transfer it to another internal number it will take more then 30 seconds for the transfer to happen.During th...
Hi, Is there any way to prevent users from clearing the call history on Cisco phones configured in CME? Thanks,
Hi Guys,I have problem at one of our customer side. When an operator received a call, and try to do a transfer (consult transfer) to a colleague, the colleague's phone ring one time and the call failed. The operator have to take back the call and giv...
HI we have 3845 model voice router. IOS: c3845-adventerprisek9-mz.124-24.T6.binI want to know do we need SRST license separately or IOS version will support SRST.
Hi all, How can i remotelly connect to a cisco ip phone? thanks.
isdn bchan-number-order ascending round-robin is applied but not workingios c3825-spservicesk9-mz.124-21.binrelevant config controller E1 0/3/0 framing NO-CRC4 pri-group timeslots 1-31 interface Serial0/3/0:15 no ip address encapsulation hdlc no log...
CUCM 7.1.5 and a 2951 with IOS 15Goal: I need to be able to dial 50# and have that passed out the FXO port, including the # symbol. **I cannot use and FXS card or ATA because the intercom system cannot "answer" the call. It stays off-hook at all ...
Hi I have a VIC2-4FXO card in my Cisco 2901 router and its not responding. i replaced it with another workiing card and still the new card didnt respond. any advice anyone? Thanks,Surendra
Hello Community, I am having an issue with AA and B-ACD.When a call comes in, it is sent to AA, which is only used to check the time. If the time falls between the opening hours, then transfer to the B-ACD script, running on the CME. The caller then ...
I have IP Communicator 8.6.2.0 running from CUCM 7.1.5.32900-2. I was wondering if there is a way of setting it up, as I can't find it anywhere, so that if I hold down on a number I get a continous touch tone. I have an emergency phone on campus t...
We're setting up CUCM for a new client and I've been working on intercoms. I've run into some issues related to both presense and barging.Because intercom speed dials cannot be set up as BLF speed dials, we're having to use additional button real es...
Hi AllWe have just created a SIP trunk from our CUCM running 8.6 and our Cisco VC device, I think its an expressway. We can make voice calls no problem from our IP phones, however when I try to make a video call from jabber client to a VC device, the...
