IP Telephony and Phones

Is it possible to configure paging in call manager 7.0 ? Pls advice..

Is citrix supported/work with IP Communicator for teleworker scenerio? alot of our teleworkers VPN in fine with ipc. we are trying to get away from giving vpn access to everyone, and would like to use a citrix solution. I believe i was told in 2008 i...

I can't seem to do it across the VPN. Everyone is default g.711Internal it works fine.The site across the vpn can not do conferencing. So it seems that something is off. I just can't put my finger on it.I have the CFB confgiure and have the MRG in bo...

Hello, The document titled "Cisco Unified Border Element for Contact Center Solutions" states that if xcoding is needed for agent phones that xcoding needs to be done on the CUBE. I have configured xcoding on the cube and this does work, but should ...

Hi all,We're deploying IP Communicator alongside a 3rd party SSL VPN which advises it supports Cisco IP Communicator 1.x+ using IP pool allocations. However, I've not managed to get it to work unless I specify the IP address for network audio manuall...

Hi guys,I am trying to setup a Trixbox conference. This is working OK but when call from PSTN then the DTMF digits are not recognized. If I call from a SCCP phone which is registered to our callmanager it is working without a problem.This is my setup...

Hi,We have a customer that has a couple of sites (one runs CUCM 6.1.1, and the other 6.1.3). Both site have Kirk 600v3 Dect systems, that use SCCP integration with the UCMs. We recently upgraded the Kirk base stations/radios to version IPfirmware_607...

Hi,can soneone please help, I have our remote sites registered to the the Call Manager Cluster with SRST in place if failure on the main WAN path. However a couple of times now on a main WAN failure the telephones have correctly registered to the SRS...

The problem is I dial my voicemail pilot number, the call is picked up but I don't get any audio output from Unity. I would expect the usual 'Please enter your PIN' etc…I am running:Cisco Unified CM Administration (7.0.2.20000-5)Cisco Unity Express...

Telepresence 500 - I am unable to consle into the hardware codec. Anyone know how to restore to factory default settings?Your help is greatly appreciated

Hi - We currently have a single site 2 node (1xpub and 1xsub) CUCM Systemversion: 7.0.2.20000-5 cluster.Our customer has requested we re-address both the subscriber and the publisher toaccommodate their new address scheme. I have followed the doc htt...

Hello all,We are currently asked by a telcom to test functionality of Cisco IP Phone 7940/60 with their SIP Server SBG (Ericsson) in a LAB environment.I was able to change the firmware from SCCP to SIP successfully (version P003-8-12-00)The Phones ar...