Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Would like to have a compatible list for phones on UC-one
Hello My question is : How can i configure a required password to make a call on Cisco phone with CME Best regards
Hi,I'm having trouble getting a 7961g with SIP firmware to register with my SIP Proxy. I've used wireshark to see whats going on at a packet level and the phone sends its DHCP requests and gets an ack fine. It then requests a file via TFTP CTLSEP...
The older 796X series phones had a really nice locking wall mount that sat the phone at an angle so if you're standing, you can still see the screen, but for some reason the newer 88XX series phones only have the one flat wall mount available that us...
I've used SIPmac.cnf.xml files to configure my 8845s. I have a lot of the features I need working but cannot crack this one. I've tried several settings that appear to deal with this but nothing is working. When I press UP on the navigation cluster I...
I have CM 12.5.1.11900-1468845 phone running 12.7(1)Our receptionist was using an 8945 phone. I upgraded her to an 8845 phone. Now when she parks a call, it goes on hold and immediately start ringing back to her phone. The park reversion and park mon...
I have been getting alerts in SolarWinds when the registered phones drop below 5% of the total. All of our devices are set to register to the same "main" subscriber, but I notice different devices trying to register with other servers in the cluster....
Is there any special config needed to make calls out from CISCO Jabber when in extend and connect mode. I can receive calls fine and was able to answer them on mobile. But when calling out, there is no call being made to remote destination nor the ca...
Hi there. I have a 7821 device on Call Manager 12.0 that is registering directly with SRST.Firmware version: sip78xx.12-0-1-11In the status messages I can see the "DNS Timeout" so I checked the configuration in Voice DHCP and there is a configured do...
I don't have any more hair to pull out! I've been stuck trying to register these phones for the last month or so. I know I'm missing a small detail, it's always something small that's missed. Can someone please look over my configures and point me in...
Sorry for this probably very basic question but I have very little experience with VOICE stuff.The problem is that our CUCM transmits a wrong number to the receiver of an outgoing call. On internal calls the number to dial is 55XX while on outgoing c...
Hi, I have the following environment where outgoing calls to external SIP telekom provider are failing. Incoming calls from the ITSP are working perfectly. CUCM => SIP trunk => CUBE => ITSPThe ITSP supports: G711A, G711U, G729a, G722.My config is as ...
Hi Team, I am having an issue where enhanced plus licenses were utilised for persons with a particular user id. However when I checked under user management, i am only seeing one device. I believe this is not the right place to check for this inform...
Has anyone managed to get this phone (8831) or perhaps some similar cisco SIP phone working with Asterisk? Regards.
Is it possible to connect 2 analog phones using the same extension on the same vg310 port?
