Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
My Company is looking at using Zebra TC51-HC devices loaded with Jabber to replace dedicated bar-code scanners and wifi phones. One issue im seeing is that the Jabber app in speaker mode is horrible/unusable. It appears that the device attempts to ad...
I have an HA UCCX environment and I recently experienced the subscriber UCCX showing in Partial Service. I drilled down under UCCX Serviceability > Tools > Control Center Network Services and saw that it was the VOIP Monitor Subsystem in out of serv...
I am attempting to upgrade VOIP phones from 7942/7962s all running SCCP on my CME routers. I have installed one SIP 8811 voip phone at our main site and have configured voice service on main CME router. The SIP phone can call all local SCCP phones an...
Hi Ok so let me prefix this by saying, yes, I know it's by design and it defeats the purpose but that's the request I have (or rather, one of the users has). Say I have a user Joe Bloggs with ext 1234 and an RD setup going to his cell phone +012345...
Hi this is kinda of a simple question but, I think there are several ways to achieve this. CUCM 11.5 I have a requirement where I have two DN's in a line group that the customer wants to ring forever until answered. Line Group RNA is 180 seconds maxi...
Existing SIP SRST configuration (been working for years) that stopped working yesterday. No changes on our end and Provider says no problems on their end. I can see incoming calls reach the CUBE but they never get to the end user. This site is S...
Hi all, I'm not able to make outgoing calls, the first thing you hear is a busy tone. Call attempt is stopped immediately. Please find attached 2 test results in the attachment. Also other relevant information: ===================================...
Hi, I am having problems with phones running on CME 10.5. It's difficult to explain so I have attached images to assist. Image 1 shows an 8811 phone with a red light next to the primary line. It also has a lot of strange numbers on the right han...
My provider is sending me payload type 100. I would like to change it to 101 within the CUBE. is there away of doing this as I am having issues with dtmf when trying to pass digits. thanks
Dear all I have a CME (Cisco 4331,Version 16.09.02, CME version 12.3) installation and I am facing the following issue: CME has a 4 FXO NIM with 3 PSTN lines on it, which works fairly well. However, when the customer forwards the calls to his mobil...
Hi We synchronized users from company AD and LDAP authentication is not enabled. My question is what is the default password and PIN for these uses? Thanks a lot!
Greetings, For 3rd party ATA's , is it necessary to order Enhanced UCL license or can we just add essential UCL as we do for Cisco ATA's? Can I add redundant power supply to BE6M-M5-K9 appliance by ordering UCSC-PSU1-770W=?
Hi all, I'm in in the middle of something , the isp is receiving the following calls and somehowe its rejecting the calls. Please find below output: We are in the fase of the cisco uc project. At the moment incomings calls are working fine but outg...
Dears,I have configured "No Answer Ring Duration" with 15sec however the internal calls keep ringing for ever unless the caller end the call or I transfer it to voice mail.please advise why the ring duration is not applied
Hello everyone, I have a problem in IP Telephony section. when i want to dial outside press the speaker button and dial the number it's goes hanging and there is no any response, but when i write the number and press the call button the call is estab...
