I have Cisco 9901 with IOS XR Configuration 7.9.21 some protocols can't appear with me like isis ,MPLS ,OSPF and multicast as per below, i think I need to install the package #show install inactiveThu Sep 19 15:58:25.193 GMT+312 inactive package(s) f...
Dear All, I have an issue with the following switches, switch 1 its could authenticate with ISE, whereas switch 2 its doesn't, when i run "sh authentication session" its has traffic in switch 1 and switch 2 no session show at all, and wh...
I have an older aruba switch with a sfp port and a multimode fiber connected to it.then I use a networkcable to the CB250.on the other end of the fiber is a CB350.when I connect the fiber cable from aruba to CB250 I get link up, but no internet.on th...
helloi tried to upgrade in "INSTALL" mode from 17.03.07 to 17.09.05(I have no HA)all seems to be ok during upgrade (see attached) , bootvar seems ok :BOOT variable = bootflash:packages.conf,12;CONFIG_FILE variable does not existBOOTLDR variable does ...
Hello all,I am planning to upgrade my DC with Nexus 5500 to 9300 series without interruption.Can you please give me advices in order to perform this properly ?
Hi: I trying to monitor OSPF in multiple VRFs. I have created multiple context in SNMP. Here is what my config looks like:snmp-server context default vrf defaultsnmp-server context abc01 vrf abc01snmp-server context abc02 vrf abc02snmp-server communi...
Have a pair of Nexus 9300s in vPC with vxlan evpn stretched vlans over to a pair of Nexus 9200s. I’d like to add two L2 vlans to the fabric.I’ve added the vlans and given them vnis I know I need to add them under the nve interface I know I need to ad...
In my SSL/decryption policy advanced settings I have chosen the option to block unknown cipher suites and therefore in my connection logs I see lots of connections that are blocked due to unknown cipher suites, which is expected. However, the partic...
Hello Everyone. I have cisco mx 700 which was installed by Government in our institution. It was previously registered to the old cucm. I have a new cucm 12.5. I want to re-register the mx700 to the new cucm but the touch panel is nowhere to be foun...
Hello Team,I have a topology as below;I have point to point connections to multiple partners who have different unique prefixes - to avoid overlapping of subnets.They need to access my internal resources - in this case vlan 50 and 70 for respective s...
Hi everyone , i am quite new . I have been stuck up from quite few days . i have to implement a solution for the below requirement . 1) i have 15 devices with same ip address ( ip address is hard coded inside and can not e changed ).2) each device...
hi all,when i try to ssh in to a switch i get a connection refused on port 22ssh robert@10.110.10.4ssh: connect to host 10.110.10.4 port 22: Connection refusedthanks,rob
I created a couple policy rules and selected the Monitor feature. After applying the changes, I am not seeing any hits on the rules I created. I found in old forums the monitor feature really doesn't work. The customers were using 2.4 at the time ...