Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Evening Guys,Searched forum for answer but couldnt find anythingWant to format a 256 mb cisco CF card. Unfortunately my existing slot0 external slot appears to be dead as the LED for this does not light upIs there an alternative workaround pleaseI ha...
Hi guys I have a small cme to cme network of 6 routers and I have h323 dial-peers between them, randomly the rtp between the sites stops working and ichange the protocol to SIP and then it works again, a week later it stops working and i change back ...
Hi All,I need to configure AA its-CISCO.2.0.3.0.tcl script for incoming calls from SIP trunk, but what I know is its-CISCO.2.0.3.0.tcl only work with incoming dial-peer not outgoing dial-peer and my SIP provider uses G.711alaw and the script working...
Now, I'm running TCL IVR on router through E1 interface. But, I have a plan to change E1 to SIP trunk.Please show me how to config TCL IVR on SIP trunk.Thanks.
Disconnect Cause (CC) : 38 and Disconnect Cause (SIP) : 503can anybody suggest me how to solve this error issue please its an urgent i am not able to get incoming calls from mobile and landline when i debug the h323 gateway i got this error
Hi all,I have a 8945 (firmware 9.3.1.19) paired with a Plantronics Savi 720 via bluetooth. I am encountering an issue with this setup when I am calling out: I hear the ring back tone but as soon as the call is established, the headset disconnects an...
I am trying to setup a 7916 expansion module on a 7965. I have created a phone button template, where the 1st two buttons are line, buttons 3-18 are speed dials, and buttons 19-30 are Service URL's. The speed dials are showing up correctly on the t...
I've noticed that the MWI light on the second line\button on our 7941\42's doesnt light up like the primary line\button does. Is this normal behavior and can it be changed so that the button does light up when a voicemail is left on the line that the...
i'm facing disconnected issue with analog lines , sometimes its working fine someday issue coming back voice-port 0/1/2 trunk-group Zero supervisory disconnect dualtone mid-call supervisory custom-cptone Cust_Tone no vad cptone BE timeouts interdigi...
Hi All, I have a strange issue that I can't seem to get to the bottom of. When the CME receives an incoming call users can only see 90 on there desk phones. I've looked back at my other configs but can't seem to see when the issue is. caller ID wo...
Hi all,Outgoing call not connecting on 1st attempt over ISDN PRI. Logs Attached.Please suggest.
Hello I have a VG224 that in one of the ports I have a modem, the issue, is that the modem is disconnected every few seconds off connected. Any ideas? Thanks.
When our operators transfer a call to another coworker they do announce the call. However, the person who's receiving the transferred call just hears silence after the transfer key is pressed. They are connected to the customer and the call is live...
Hi All,I am running CUCM 8.6 would like to know if its possible to disable caller ID. i mean i do not want to send any digits at all to SIP Provider. Ofcourse my SIP provider is willing to accept this type of call.e.g. Calling number 1000 called numb...
hello mates, office wants an automated voicemail options so press 1 for shoes department and 2 for housewares up to 10 options. How do i make the dial pad for pressing option 10 in unity? cheers,Matt
