Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I cannot have the CUCMs register with a gatekeeper since there are already Inter-Cluster Trunks (non gatekeeper controlled) configured. Gatekeeper will be used just for TEHO. Since you can configure H323 and MGCP on a gateway can I configure gatekeep...
Available virtual memory below 30 Percent.tomcat (925 MB) uses most of the memory.The alert is generated on Wed Jan 26 16:11:35 GMT 2011 on node X.X.X.X.We are getting the above mentioned alert quite often.I have been restarting the TomCat service to...
Hi, We have two users where when they try to login into the voice mail, they get this, invalid selection message, tried changing the password several times over , but its of no help. the extension and all other stuff is fine. Cisco unity connection ...
Hi all,We have lots of 7960 phones deployed which all work really well. We have Ext Mobility overlaid on these, and staff can happily logout and login where they like with no issues.We rolled some colour 7970 phones out a few years ago and found that...
What are the ramifications of having a gatekeeper controlled trunk and a non gatekeeper controlled trunk off the same cluster? Thanks
Hello All,We are trying to make a video call from CUPC version 8.5 to Tandberg E20 and the video call is not possible, we only have an audio call without video. ¿Can you tell us if the problem is probably compatibility? ¿Someone did before this test?...
I have an PSTN E1 circuit into a 2901 voice gateway. I have one user on a specific internal extension who is convinced they are having calls dropped.When all 30 channels are busy it's near impossible to trace a call through the debug output.Is there...
I have an issue where a remote office that registers with a CUCM over an MPLS link - the MPLS failed and the phones successfully failed over to their local SRST router. The MPLS was down for a period of time, so the site was reconfigured with a L2L ...
Hi.Currently I'm working in a Cisco/Nortel integration using an E&M Trunk Card on the Nortel Side (NT8D15AK) to a VIC2-2E/M VIC card on a Cisco 2851. After trying all possible pinouts it is still not working.Is there anyone that was able to use this ...
Hi all.Where we can get good UCCX and CRS training videos which need to be from scrach.Can we get UCCX software like CUCM ?Please provide me the details which will be very useful for me.Thanks in advanceRegardsKarthik
Hi,Which is the upgrade path for 7.1.5 to 8.6? All the data is migrated? Is there any special DVD for upgrade or is it valid the one of the installation?I have a DVD with version 8.6, which is labeled as "Installation disk" (not upgrade disk).I have ...
Hi,I am configuring auto attendent in cisco unity connection 8.5. I need the configuration steps. When ever the caller makes a call it should land on the auto attendent and auto answer the call with custom greetings and give the option to dial the ex...
Hi,Can someone guide me that how to enable full 30 channel pri on router knowing that telco has enabled the same fron theri end. Bwfore we had 10-channel pri. Voice gateway protocol is h323 not MGCP.
44102152 à 315244102160 à 316044102153 à 315344102171 à 3171 (one can be like /^2171/ /3171/)44102128 à 322844102101 à 320144102130 à 323044102194 à 319444102104 à 3304What can be the best (or one) translation rule for above-mentioned numbers
Hi,I have this setup:1. Centralised multisite running CUCM 62. branch sites A and B get services of main CUCM 6.3. branch site C has a voice gateway connected to an avaya phone system using H323.What works:1. Branch A and B calls are successful2. Bra...
