Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi Guys,Kindly help me in configuring Cisco Conference station 7937 on cme 8.6. I cannot find any document. I need to make the conference station register to the cme 8.6. Also the 7937 firmware files to be uploaded to cme.Thanks in advance.
At the moment we add many new users to our system (CUCM v7) every day. We have two ways of doing this either adding the details manually or using BAT but both are very time consuming. With BAT we require 6 different csv files for the UDP, User, CUP...
Hi all ,What is meant by post mortem process when gateway is down or WAN down or calls are not maturing ?I was new to hear this , kindly give me some light on thisThanksKarthik
Are there any gateway sizing options document for Router 3925E?We are trying to figure out the scalability numbers for 3925E if we use it as a router and a vxml browser.The sizing table below only talks upto 3800 series.http://www.cisco.com/en/US/doc...
Hi all,I need H.323 softphone, that I can add to CUCM. I need it for lab purposes to study H.323 in more details. So please if somebody can tell me about a good H.323 softphone.Regards,
Hello All, I am using Cisco call manager 6.0 and i am using public IP on it.I configure it well now my phone are registered from every network but i have one problem that my voice is going but i can't hear the another side voice. On ...
Guys,I am having this issue and i just need to verify, or justify to the telco that my configs are correct and the issue is maybe a loop on their switchingi've tried changing isdn switch-type and related configs to primary-net5 as this is E1, but no ...
Hi,i have a little problem with MWI. If i have new phones it doesn`t work. It works only if i enable a notification device and make a call to the voicebox. After that i can remove the notification device and it works with the phone. But it is annoyin...
Problem Description : We have got a cisco ip phone user whose DID was previously being used on a Turret phone , we configured the same extension on the Cisco phone ( and removed it from the turret phone ) , but the issue is that when an inbound exter...
Hi,We need to connect expansion module in 7961 phone model and then need to configure in Call Manager.Could you please help me out here how we can configure the expansion module in Call Manager.Expansion Model : 7915 UC Phone Grayscale Expansion Moud...
Im trying to test adhoc conferencing on a newly installed phone system (UCMBE 8.x).I'm using the following steps:Dial participant 1, establish callpress confrn buttonDial particpant 2, establish callpress confrn buttonWhen I press the confrn buttton ...
We have intagrated our 5.1 CCM with Microsoft's AD, however when we try to login to the ccmuser page we get an error saying "Access to the requested resource has been denied"I have setup "LDAP Authentication for End Users" but still no luck.
Odd issue--new CUBE implemented, same configuration as several others i've implemented with no issue, same provider. What i'm getting though is on the new trunk, the DID of the phone shows up as the inbound caller-id...haven't seen anything like thi...
hi,witth the cisco phone designer it is possible to upload new images on custom phone and not for all users.How could i do this without the designer?I found only this doc https://supportforums.cisco.com/docs/DOC-11493 , but this is for all users in t...
Hi All,Please tell me how to trace the call in CUCM..i want to know when user call from the ext to any number ,How dialed number is translating and wich path(Route pattern) it is taking..
