Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Due to a solution that has been given to us. We are left with looking at configuring multiple subnets on a single voice vlan. This goes against best practice but has anybody actually configured this in the past?
Dear All is ther any possibility to add SPA521S phone into cisco callmanager veriosn 7 or 8?
Hi,is where any chance to get this function enabled on a CME 8.0? I didn't find anything only for the CUCM Version 6 and above.If not, is where an work around to get this "boss - secretary" functionality?Thanks@Lex
Hello All.Please tell me if i can use Arabic language with cisco devices:cucmattendant consoleunity conenctionuccx
Hi,Running UCM 8.5 with 2 nodes, Publisher and a subscriber along with Unified Presence. I am getting an error in Unified Reporting in Unified CM Rhosts saying that " The rhosts file does not match the publisher".Please let me know how to resolve it ...
running CUCM 7.1.5.While on the phone, another call comes in and there's a beep that results. Under certain circumstances, it can be very annoying. Is there a way to disable that?
Do “Unified communication” VMWare support is only on UCS alone or we can install the CUCM 8.0 and later in any existing VMware server in the customer place..
Hello,I've got a non-standard, and from what I gather non-supported, configuration that I am trying to get working. In one of my sites, there is a room with no data jack and no easy way to get it there. So I am trying to hook a phone up wirelessly.He...
Good Day - I have x24755 that is forwarded off-net to an answering service. However when x24755 is called the calling partie's number is shown on the answering service's caller ID instead of x24755 ID (9566984755). As a result the answering service...
Hello Cisco Support Forums,We have deployed a CME system with some 6941 phones, and we have ran up against a limitation of the phone. It seems that the 6941 (unlike the 7900 series) cannot create a second channel unless you use the conference or cal...
Hi guys, Q regarding Path replacement.We have CUCM v7.1.5 linked with some Siemens PBX's. Path optimisation works in most cases very well. In soms cases it also works but too well. Let me explain.Call comes in via CUBE (SIP trunk). Call is sent via Q...
Hi All, Customer would like the the ability to restrict of release outbound CLI. Previously they had the 9.@ pattern set to prefix with 141 and and 8. pattern to release CLI. Changed the solution to route out a CUBE instead of MGCP gateway. As 141 no...
I have two locations connected via point-to-point wireless link, the Main office has the CUCM ver4.2 with 8 phone lines. The second facility is a charter school. Many customers and parents complain when they call the school number it is always busy. ...
Here is the topology:fax->ata->cucm->h323 VG-------->mpls---------->h323 VG->PBX (through E1) ---> faxI have a very very bad fax quality or half pages ONLY from this way..Any ideas of wha to check..?Thanks
Hi,If i configure IDLE URL in enterprise parameters of CUCM 7.x, and when later when user login into a phone using Extension mobility, will these IDLE URL will still be working or it will be over written. Device profile does not have IDLE URL paramet...
