Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello all,I have call manager 8 and couple of cisco ip phones. Phones are connected into the Linksys switch SRW224P (no CDP support). I was able to configure admin vlan manually on the phone. It works ok and phone tags its own traffic. When I configu...
On a 7.1 cluster there are 10 servers, one publisher and 9 subsequent subscribers. On the publisher there are certain phones and gateways that show up in the searches. On some of the other servers, there are other gateways and phones that come up. ...
I recently upgraded a UC-520 system from a very old version of CUE to the latest version 8.0.4. (UC 500 Series - Administration Version 8.0.2). I restored factory default because I had some issues and wanted to start fresh. Everything went seeming...
Dear all,I want to know what is the difference between CP-7940G-APAC and CP-7940G-APACSP, it seems that CP-7940G-APAC include the Phone licenseThanks,Kirin
Hi!I have a problem with B-ACD on CCMe. B-ACD has two options: transfer to hunt group and dial by extension. If I call to B-ACD from internal IP phone everything works fine (both options). If call comes from SIP provider I can chose any option, but...
Hello,I think I have a slight issue with the way my cluster is set up.I have one publisher and one subscriber.They are both running 7.1.5.32020-1.When our partner came in to do the initial build of the CUCM in their documentation it had said that all...
I'm trying to enable liverecord and I get the error "current version of IOS not supported" I have upgraded the IOS and get the same error. I am trying to configure this feature through the CCA tool. What version of IOS for the UC520 do I require to e...
Hi!We are going to migrate a Call Manager Express router to become a regular remote PSTN GW with the phones registering to a central CUCM instead. CUCM version is 7.1.3. What is the best way to collect the date i.e phones data ect that is to be uploa...
We are looking into the possibility of replacing our PRIs with new ones. The new company has asked for the number of digits that we are accepting from the old company. Looking at our dial plans in CUCM 7.1 it looks like we are only accepting 4, but I...
Attempting to setup redundancy on the gateways, in case of a failure. The digit analysis shows the call being delivered to the failover gateway with the 9, however a debug isdn q931 shows the call being delivered without the 9. Why would the digit ...
Dear All,I have configured an h323 trunk between my cucm 7.1 and avaya cm 3 which is located in a different country.It is working fine from our ip phones the avaya phones, through a route patten 50xxxxx.I can connect to avaya and make local calls fro...
Hi,I am new in voice field. I would like to know about licensing in Unified communication Manager.I have installed a call manager 7.1 as publisherI would like to add a second call manager that is a subscriber to the cluster.On my publisher licensing,...
Voice Gaeway, suddenly E1 PRI controller E10/0/0 and associated serial interface channel flaps, going down and up several times in a minutes.Once Voice Gateway is restarted it is back to normal.Getting following logs during serial flap.480: 1153639: ...
Have a scenario I'm trying to build out. Not sure if it's possible or not.In CUCM is there a way to make the calling party phone appear as if during a ringing state that it is actually ringing a different destination than it is calling.Example.Phone ...
Is there a Cisco access switch feature to disable a switchport if a device is attached directly to the port and it is not a Cisco phone?
