Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I setup the attendant console per the Features and Services guide. Whenever I start the attendant console application it launches, when I hit to Go Online it errors out saying "Initialization of call control failed" I created the ac and ac2 user, m...
I would like to know how to block inbound calls to some phone extensions. When I say only inbound I mean block inbound calls from but permit outbound and receive/make internal calls. The options ofered by ccmanager don't cover this option.thanks
I am trying to get the tabsync application to work. When I try to connect/logon I get the following error:"unable to login (username) with configured password"I have gone in a reset both the password and pin for this user account. I have added the ...
I've always had a suspicion that my dial-peers are not functioning like I think they should, but haven't ever been able to prove it. Obviously this is somewhat of a minor issue since we're able to place/take calls without any serious problems, but w...
How to Enable beep or recording tone on an active call in CME
I have reset the private password phrase but when I try to install the new subscriber server it errors on the private password phrase. Error is "Passwords do not match or there is a Network connection error" the systems are on the same switch, there ...
Hi All,Anyway to shorten the call setup time for CallManager to PSTN through voice gateway and CCME to PSTN? Seems the call setup time by default to PSTN is longer then using traditional PBX.Best Regards,Teru Lei
Hi, can anyone advise how you configure a PRI that has only 20 channels not the usual 30?
A customer has CM4.2 with a H.323 voice gateway for PSTN acces and Multimedia terminals with an H.323 client for telephony.Calls from the PSTN are sent with the calling number in the H.323 setup to the H.323 client.After an upgrade to CUCM6.0 the cal...
Previous to the upgrade from 3.3, we could dial *, plus the 4 digit extension and transfer a call directly to individual mail boxes. Now, it takes me to the call handler and forwards me automatically to an operator extension, anytime I dial * plus a...
Hello,I have two router : a 3745 with VIC-2E&M and a 1751V with VIC-2E&M.I want to tranfer call from the 1751V to the 3745 with these cards.(router )E&M <-> E&M (router)Is it possible? How to do? How about connector and pinouts Thenk you very much.
I received a complaint that a user is not recieving calls to his extension and the voicemail light was not turning on. I have tried these solutions but ended up in a worse situation than I started. I was able to dial the extension but now I ust get a...
Hi!I have defined Meet-Me number. How can I restrict access to this number (calls from PSTN), in the way that only specific external telephone number can access this pattern?Is this possible?thx
Hi!Maybe someone have encountered this problem too...When secretary wants to transfer incoming call from outside to one of employees extention there is a delay about 5 sec. She uses consult transfer and when she presses "Transfer" softkey second time...
how to manipulate the outgoing number?forexample, phone registers on the router with internal number 1006, and also appears dial-peer 1006$, and calls I can make only INTERNAL! FROM 1006 to 1007 ans so on.But I cann't call PRI number, like 212345dial...
