Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello, and thank you in advance for taking time to review my issue. We are having issues w/ lack of audio over ip phone, into WebEx conference calls. I'm assuming it's something to do w/ our settings somewhere, and not on the WebEx side. Anyone r...
Hi Guys I tried to config a sip trunk on cisco 2811c router and I believe it does not support some VoIP commands like allow connections sip to sip in voice service voip is it true that this 2811c does not support CME VoIP commands even with differ...
I explain the form: From a 666 extension with local calls, the call can not be transferred to extension 665. Greetings.
Client is using jabber. And complaining about it resetting. And when I look in syslog I see the following. After which the phone will re-register. LastOutOfServiceInformation: %[DeviceName=CSFNZSELYERMO][DeviceIPv4Address=10.211.137.25 / 0][IPv4Def...
Hi All, We have a working older CME/CUE system. On only one particular extension, when connected to the AA, if you dial the extension, it hangs up on you. - other extensions work properly. I've attached a buffer trace from CUE that contains a trac...
i cant seem to find a document listing all the supported phone models on 11.5 , are these phones supported on 11.5 ? 79456945692179116941
Hello all, I try to configure E1 fllow on my CME (3800 Software (C3845-ADVENTERPRISEK9-M), Version 15.1(4)M3) I configured: card type e1 0 1 ! card type command needed for slot/vwic-slot 0/3 isdn switch-type primary-net5 ! voice-card 0 dspfarm ds...
Hello, I have a Cisco ASA 5510 Version 9.1(7)9 with multiple tunnels, (2) of which have duplicate hosts. These 2 tunnels are completely separate no communication between the two. The Chicago tunnel was just added and appears to be having issues w...
hello i have one question? after upgrade to sip firmware my phone 7960 ,I receive the following message unprovisioned
Dear I want to setup a sip trunk with XYZ company call manager, I want to know the SIP version supported by CUCM 10, 11,12 Thanks
Dears, I m building a secure sip trunk between the 2 no's of CME with secure RTP , the sip trunk between the CME forms successfully but the SRTP fails between the phones , when it is normal RTP it works fine but with SRTP it fails I cannot establis...
Hello Everyone, I think I am so close to getting this working. The first dial-peer accepts the call from my provider. The invite comes to 1777XXXXXXX. I have attached a sip-profile to this dial peer: voice class sip-profiles 2request INVITE peer-he...
Not sure where to post this, but hoping someone can't point me in the right direction. We are a multi continent company (as of recently) and I have been asked how to provide a local dial in number for conferences in the US. For instance, we have ...
Hi all, I have a problem getting 7911G's to register on my CallManager Express. The problem appears to be that the LoadFile on the phone is saying term11.default rather than SCCP11.8-3-3SR2S. I had one phone out of two working last night and it ...
I plan to install a new cluster CUCM 10.5 and move some licenses to the new cluster.This new cluster will be a single site model without network access to the current ELM server.Is there a way to move licenses between ELM servers or do I need to ask ...
