Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I would like to know if a line is "off hook" or if the line is busy. I am the admin, and would like to reboot the 8851 phone for a variety of reasons (In this particular case to enable bluethooth). I have googled this a lot, with no info. How do I...
I am trying to register and use a Lifesize VIdeo Conferencing Codec (Icon 600) with our Callmanager phone system. I have setup a 3rd party advanced phone and extension with the Icon's MAC address and setup an extension and user for this phone. (...
All, Bit of a strange one... We have a Hunt Pilot in place with a Hunt List and Line Group, when we call the Hunt Pilot internally, calls route fine to the LG and pickup works fine. However when the call is transferred from a Unity Call Handler with ...
Anyone know if these ATA 190-SC models, with the 1 analog port can be used on Communications Manager?
Have a problem (internationally) where we forward a number to another local in-country number. However when we send outbound calls we append a + sign to them. This has caused the transfer to fail for mobile or land line users in-country because the...
Dear All, I have a quick question. Can we do call forwarding for one user who receives international call on his IP phone to other extension. Only the international call. How to do that please? Thank you
Hi there I am concern that I have a sip trunk to some avaya PBX (somewhere else), they point their SIP Trunk to the ip address of my subscriber, we had to power down my PUB, and my Sip trunk came down as well, I thought that my SIP trunk was going ...
Hi all, I have a configured MGCP and the gateway is reqistered with an E1 line. The problem is that DTMF is not working. my MGCP config is as follows mgcpmgcp call-agent 172.18.30.10 2427 service-type mgcp version 0.1mgcp dtmf-relay voip codec low-b...
is there a way to modify speed dial without using the manual method .. for example when someone leave the job and someone replace him i had to manually change his name on each speed dial list that he was in .. so is there a way to associate the numbe...
How can I figure out which voicemail boxes (aliases) are returned in a Directory Handler search? Is there a log file that shows search details? I have a voice enabled directory handler. A certain username (Sam Smith) gives two returns. One of these...
Hello all...can some one please advice what is the cause of the call getting dropped right at 7 seconds mark...outgoing is no issue....I am struggling with this system and need help. sh run attached.
Hi,- Branch site have sip phone 7841 model. Phones successfuly goes into SRST while WAN connectivity lost.Phone keep registering in SRST and won't re-register to CUCM when WAN connectivity restores.As workaround i have to give "no voice register glo...
We have started having some of the 7841 phones with multiple lines configured on them have the first line (top left on display) suddenly disappear then reappear. The other lines don't do this. However when this does occur the phone does allow you t...
Hi, I am using CIPC 7.0 and post configuration in CUCM with the MAC ID of the Laptop the communicator starts but the screen is blank. no extension number, no softkeys etc nothing showing. When I tried to do wireshark I can see the below error - "IP C...
Good Day,Recently I am having issues with one of my distribution list using the dispatch message feature - 2 out of 5 members of the distribution list's voicemail is not updating when the message is received or updated by one of the members. Please l...
