Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello Everyone, We have CUC integrated with CUCM using SCCP. We plan to move from SCCP to SIP. What would be the best strategy to accomplish this task with minimum downtime. Please note that the availability of voice mail is crucial for our business...
Hello, Anybody knows if this voice gateway supports 802.1x, in particular EAP-TLS? Regards.
Hi, I'm trying to setup recording on demand from phones using Built In Bridge and record softkey. Recorder Server is Enghouse QMS 7.1 (use SIP trunk and TAPI to CUCM). When record key is pressed screen display "Recording Failed". After tracing on...
Hi guys, I need add one external number to receive calls to a line group. Is this possible? Thanks
I need some help to convert a 7960G Phone with SIP back to SCCP. Any help would be greatly appreciated. Thanks!
A 7962 goes into DND mode periodically. This phone doesn't have any DND option in the softkey or phone templates. So, they can not be turning it on from the phone, even by accident. I have to go in and uncheck the Do Not Disturb box on the phone a...
Hello community, We are facing an issue with DTMF relay. Sometimes, digits are duplicated Topology: DECT ANALOG -----qgig----2921----mgcp----CUCM GW is mgcp and DTMF is configured for OOB We checked the traces and found the following: Apr 10 20...
Hi there, We have a SIP Trunk directly to TISP (Without CUBE/GW) and I've been asked to filter incoming calls by Calling Party Numbers, so far everything works properly. In addition I need to permit anonymous incoming calls and here is the issue. I...
Hi , Good Day . I am working on a issue on the call forwarding on the skype for business 2015 . My customer has integration of CUCM and SfB with SIP trunk . Inbound and Outbound Call from SfB user are fine and they are able to set the call forwar...
I have a customer who is a small school county school system. They have one school out of 8 which is have audio quality issues only with the voip paging through the Cisco IP phones at one location. The audio during the page is slightly garbled, ju...
Short version: Can I use a Raspberry Pi to somehow send a signal to UCS to start a phone call? Long version: I'm looking for a way to have a Raspberry Pi run a validation check on a server and kick off phone calls to some of our employees if the ch...
I'm trying to understand why I find these IPv4 to IPv6 mapped addresses on my Publisher when I run a show network status command (this us a truncated list) tcp 0 0 ::ffff:10.1.200.31:59378 ::ffff:10.1.200.31:1510 TIME_WAIT - tcp 0 0 ::ffff:10.1.200...
Working with Silent Knight SK-5104 fire alarm dialer and need to configure the VG202 to support Contact ID format. Anybody had to deal with this and how did you over come the issue.
We have 2 CUCM cluster in different cities connected via a private link and throught a FW in every site. So, we need to send calls back and forth and we are thinking of configuring a SIP Trunk with MTP required and we are not quite sure if CUCM will ...
I am having issues with one of our sites that is setup with a cisco 2921 that has 4 POTS lines in a hunt connected to FXO ports on the gateway. Local calls complete fine but when dialing long distance I get the message "we're sorry your call cannot ...
