Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Dear All I have a Cisco UC560 and I would like to register 78xx phones with this. Please find the attached hardware, IOS & CME information below and suggest.. Thank you in advance
I have configured hardware transcoder on cisco IOS gateway. their are two voice cards with dsp services dspfarm ,how to increase maximum sessions inn a dspfarm transcoder profile?currently it is showing 1-28.When I am trying to run command dspfarm tr...
We have 2 gateways each has a max conn 25 command set on the ITSP dial-peer. Once 25 calls have been reached on a gateway, the 26th will failover if there are spare sessions on the other gateway. Is there a way that if the 51st call is attempted, tha...
Hi all! I'm stuck. I can pickup or transfer all incoming external call (SIP) ---> to SCCP (7970,7940,...) (or SIP) phones. I trying pickup from SCCP 7970 When i call inside (by local numbers) - pickup and transfer working well - both side sip/sccp. ...
I recently came across a fax issue at my customers site. They are using ATA187's to convert their analog signal to digital. When comparing the configuration of this one ATA to another, I found that the media resouce group list was not set. My questio...
Hi All, I would like to know how could I differentiate/compare any given call manager servers?? And also know prerequisite before choosing version? Thank you in advance...
hi dears , did the cisco router 2851 supported cisco jabber android phone ?
What is the behaviour of a trusted relay point? If use trusted relay point box is checked on an ip phone (in our case thats a 7985 video phone) and a transcoder is marked as a TRP, does this get invoked for every call that is made to and from the ph...
Morning all,I am attempting to remove the incoming call beep (single beep) that occurs when someone is on the phone and another incoming call appears.I had a look at the DND settings of the device profile and managed to remove the beeping sound. Howe...
Hello guys , My confusion starts from the Title so please be patient on me because my head is fired up while studying Translation & Transformation pattern. What comes to my head : Transformation Pattern - Applied on route pattern or route lists an...
Hi Guys, I need to setup a call routing in this way. I call 2000 and it rings 2010,2020,2030. All want to be able to answer and talk on that call. I will be able to use hunt group to send over call to multiple line but how to configure the way so m...
I am using 3rd party SIP phones that occasionally "time out" and need to be reset (unplug, plug back in) to start working again. They are configured as dial-peers. Is this the correct way to configure a SIP phone? Is there any logging information to ...
Hello, I want to ask for some help, cause I don't understand anymore the behaviour of my phones. I have 4 Cisco 8841 and 1 Cisco conference phone 8831. The phones are registering very well with the Cisco 4331 ISR router and I can place inside calls w...
I have an intercluster trunk between a CUCM 7.1.5 system and a CUCM 11.0 system. I can make calls from the 11.0 system to the 7.1.5 system, but calls fail when I try to make a call from the 7.1.5 system to the 11.0 system. I have verified that the I...
All, I have four POTS lines that connect into a router at one of my remote locations. When a 911 call is placed, the POTS lines are the preferred path to take. Is there a command on the router that I can execute that will show me the recent calls th...
