IP Telephony and Phones

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

All I can find, regarding syslog settings in the CLI command set is this: utils syslog test Which just sends out test Alarms.    Hopefully I'm missing something.  But is there a way to see the syslog settings from the CLI?  I basically want to see t...

I'm trying to configure a VG202 to prefix all outgoing calls with a 9, If I configure the Gateway in CUCM 11.5 and prefix with a 9 I do not get a dial tone so unable to dial the number required.   Basically we have an analogue alarm box that is preco...

martynch1 by Level 1
  • 405 Views
  • 3 replies
  • 0 Helpful votes

Hi All,   We are about to configure a new ISR 4331 router as voice gateway. It has in-built IOS software - Cisco IOS XE Software, Version 03.16.04b.S. Is it good to proceed with voice configurations on same IOS or do we have to download any other IOS...

Hi all, I'm in charge of a project for setup a Disaster REcovery solution for our UC application. We are running different CUCM cluster (with CUC and IM&P + Expressway additional services) and I would like to understand which is the best solution to ...

fpiccinin by Level 1
  • 7086 Views
  • 2 replies
  • 5 Helpful votes